Panasonic DP-C305 Service Manual page 479
Hide thumbs
Also See for DP-C305:
- Operating instructions manual (112 pages) ,
- Scan/email manual (62 pages) ,
- Service handbook (808 pages)
Table of Contents
Advertisement
Code
Mode
Phase
436
G3 RX
438
G3 RX
456
RCV
457
RELAY
XMT
CONF.
XMT/POLL
459
RCV
490
RCV
494
RCV
495
XMT
RCV
496
XMT
501
XMT/
RCV(V.34)
502
XMT/
B, C, D During reception, CD turned OFF,
RCV(V.34)
503
XMT/
B, C, D CS of modem is not able to turn ON
RCV(V.34)
504
RCV/V.34
(Polling)
505
XMT/V.34
(Polling)
540
XMT ECM
541
XMT ECM
542
XMT ECM
543
XMT ECM
Ver. 1.1
Fax Information Codes
Description of Problem
C
DCN received after transmitting
FTT.
B
Received TSI is refusal ID number
as Junk fax.
Note:
This error code is not indicated
on LCD, is recorded for RDS.
B
Received relay transfer request, or
confidential document to distribute
to an end receiving station, or all
confidential mailboxes are used.
B
Remote unit does not have
Relayed XMT, or Confidential
Comm. capability.
C
Failed training in Phase C.
C
Sum of error lines exceeded the
limit (Function Parameter No. 70) of
64 lines.
C
Interval between two EOLs was
more than 10 sec. when receiver
received message data.
C
During reception, CD turned OFF,
or continued ON for long time.
During communication, lost loop -
current.
C
CS of modem is not able to turn
ON.
B
Incompatible Modem on the
Remote unit.
or continued ON for long time.
During communication, lost loop -
current.
during training.
B
Polling is rejected from the remote
station.
B
Polling XMT is rejected.
B
No response after transmitting 3rd
CTC, or DCN received.
D
No response after transmitting 3rd
EOR, or received DCN.
D
No response to the 3rd RR
transmitted, or received DCN.
D
T5 timer (60 sec.) elapsed without
MCF.
Transmitter is defective or incompatible.
Line quality is poor.
Received TSI (ID number) is registered
in Junk fax Address Book.
Line quality is poor. (Training signal is
distorted due to line noise)
FCB PCB is defective.
Line quality is poor.
FCB PCB is defective.
Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
FCB PCB is defective.
Line is disconnected.
Transmitter is defective.
FCB PCB is defective.
FCB PCB is defective.
Line is disconnected.
Transmitter is defective.
FCB PCB is defective.
FCB PCB is defective.
Line is disconnected.
No polling original is set.
No polling original is set.
Incompatible interface.
Line is faulty.
FCB PCB abnormal.
Remote unit is abnormal.
Remote unit is abnormal.
479
DP-C405/C305/C265
Cause
FEB 2008
- Quick Links:
- Error Codes (for Copier)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
