Panasonic DP-C305 Service Manual page 478
Hide thumbs
Also See for DP-C305:
- Operating instructions manual (112 pages) ,
- Scan/email manual (62 pages) ,
- Service handbook (808 pages)
Table of Contents
Advertisement
Code
Mode
Phase
407
XMT
408
XMT
409
XMT
410
RCV
411
RCV
(Polling)
412
G3 RX
414
RCV
(Polling)
415
XMT
(Polling)
416
RCV
417
RCV
420
RCV
421
RCV
427
G3
RCV
433
XMT
RCV
434
XMT or
RCV
Ver. 1.1
Fax Information Codes
Description of Problem
D
Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN.
D
Transmitter received RTN after it
transmitted EOP, MPS, or EOM.
D
Transmitter receives PIN after it
transmitted a post message, such
as EOP, MPS, EOM, etc.
D
Received DCN while waiting for
post command. (EOP, MPS, EOM,
etc.)
B
Received DCN after transmitting
NSC.
B, D
No response within 12 seconds in
NSS/DCS/MPS wait state. (After
transmitting FTT)
B
No response received after
transmitting 3rd NSC.
B
Remote side attempted to receive
message from your machine in
polling communication.
D
Receiver did not detect post
command, such as EOP, MPS,
EOM, etc.
C
Receiver returned RTN in response
to post message.
B
T1 timer (35 sec.) elapsed without
detecting 300 bps signal.
B
Busy Tone is detected after sending
NSF Signal.
B
DCN received to NSF/CSI/DIS
transmitted.
B, D
T.30 Protocol abnormal.
B
CD (response from Modem) did not
turn OFF within 180 sec. after
receiver detected FLAG signal.
Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
FCB PCB (Modem) is defective.
Receiver receives data with error. (Line
quality is poor)
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
Receiver receives data with error due to
poor line quality, and receiving operator
requests voice contact.
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
Interface or line is faulty.
Transmitter is defective.
Transmitter is not ready for polling
communication.
Password does not match between the
transmitter, and the receiver.
Transmitter is defective.
FCB PCB is defective.
Password does not match between the
transmitter, and the receiver.
Transmitter is defective. (No original,
document jam, etc.)
Inform the remote side that your
machine does not have the polling
transmission feature.
Transmitter is defective.
Line quality is poor. (RTC signal is
distorted due to line noise)
FCB PCB is defective.
Line quality is poor. (There are
excessive errors in received data)
FCB PCB is defective.
There is wrong incoming call.
(Non-facsimile communication)
Transmitter is defective.
FCB PCB is defective.
Remote station disconnected the line.
Wrong number is dialed.
The interface is incompatible.
Defective remote station.
Remote unit is defective.
FCB PCB is defective.
478
DP-C405/C305/C265
Cause
FEB 2008
- Quick Links:
- Error Codes (for Copier)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
