Panasonic DP-C305 Service Manual page 565
Hide thumbs
Also See for DP-C305:
- Operating instructions manual (112 pages) ,
- Scan/email manual (62 pages) ,
- Service handbook (808 pages)
Table of Contents
Advertisement
No.
Parameter
010 TX Level
011 RX Level
012 DTMF Level
013 G3 RX EQL
014 G3 TX EQL
015~
Not Used
016
017 TX Start
018 RX Start
019 ITU-T V.34
020 ITU-T ECM
021 EP Tone
022 Signal Interval
023 TCF Check
Ver. 1.1
Function Parameter Table
Selections
00 = 0 dBm
~
-15 = -15 dBm
-43 dBm
-38 dBm
-33 dBm
-48 dBm
00 = 0 dBm
~
-15 = -15 dBm
0dB
4dB
8dB
12dB
0dB
4dB
8dB
12dB
2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps
2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps
Off
On
Select
Off (Invalid)
On (Valid)
Off (without EP Tone)
On (with EP Tone)
100 ms
200 ms
500 ms
Normal (Short)
Long
Selects the TX signal output level, 0 to -15 dBm in 1
dBm steps. (Refer to Chapter 4.3.)
Selects the receiving sensitivity of -33/-38/-43/-48
dBm.
Selects the DTMF output level, 0 to -15 dBm in 1
dBm steps.
Selects the cable equalizer for G3 reception mode,
0dB, 4dB, 8dB or 12dB.
Selects the cable equalizer for G3 transmission
mode, 0dB, 4dB, 8dB or 12dB.
Selects the transmission modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 32.
Selects the reception modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 33.
Selects whether the ITU-T V.34 is Off, On or Select.
Select: Select whether the ITU-T V.34 is Off or On,
when entering Phone Book Dialing Numbers
or Manual Number Dialing.
Select the ECM mode.
Selects whether to add the echo protect tone on V.29
mode.
(Used when Echo Suppression is disabled.)
On : Add
Off : Do not add
Selects the time interval between the receiving
signal, and the transmitting signal.
Selects the TCF check interval Long/Short
565
DP-C405/C305/C265
Function
FEB 2008
- Quick Links:
- Error Codes (for Copier)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
