Panasonic DP-C305 Service Manual page 480
Hide thumbs
Also See for DP-C305:
- Operating instructions manual (112 pages) ,
- Scan/email manual (62 pages) ,
- Service handbook (808 pages)
Table of Contents
Advertisement
Code
Mode
Phase
550
RCV ECM
554
RCV ECM
555
RCV ECM
570
RCV
571
XMT
580
XMT
581
XMT
582
XMT
623
XMT
630
XMT or
RCV
(Polling)
634
XMT
638
XMT
712
XMT
714
XMT
RCV
715
XMT
716
XMT
Ver. 1.1
Fax Information Codes
Description of Problem
C
Timer between frames in phase C
has elapsed.
D
Transmitted ERR after receiving
EOR.
D
Transmitted PIN after receiving
EOR.
B
Password, or machine code did not
match during remote diagnostic
communication.
B
Remote unit did not have the
remote diagnostic function.
B
Sub-address transmission to a unit
that has their DIS bit 49 (NSF bit
155) OFF.
B
Sub-address Password
transmission to a unit that has their
DIS bit 50 (NSF bit 156) OFF.
B
Sub-address SEP (for Polling)
transmission to a unit that has their
DIS bit 47 (NSF bit 130) OFF.
A
No original was in the ADF. (Built-in
dialer engaged)
B
Redial count over.
Redial count over with no
response, or busy tone was not
detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
Power turned Off with applicable
data in memory, or during
communication.
LAN
Unknown email address replied
from the Mail Server.
LAN
LAN Interface error.
Cannot logon to the LAN.
LAN
TCP/IP connection timed out.
LAN
Cannot logon to the LAN.
Defective remote station.
Faulty line.
FCB PCB abnormal.
Faulty line and Operator Call requested
by RX side.
Sub-address transmission to a unit that
has no Sub-address function.
Sub-address transmission to a unit that
has no Sub-address function.
Sub-address transmission to a unit that
has no Sub-address function.
Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the ADF.
No dial tone detected. Sensor dial tone
is not detected. (Country dependent)
Busy tone is detected. (Country
dependent) T1 timer (35±5 sec) elapsed
without a signal from the receiver.
Power switched off.
Power failure occurred.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
480
DP-C405/C305/C265
Cause
FEB 2008
- Quick Links:
- Error Codes (for Copier)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
