Sony SRW-5100 Operation Manual page 124
Hd digital videoscassette player
Hide thumbs
Also See for SRW-5100:
- Operation manual (34 pages) ,
- Brochure (20 pages) ,
- Brochure (2 pages)
Table of Contents
Advertisement
Item number
Item
628
REMAIN TIME
DISPLAY
629
CONDITION
DISPLAY VIDEO
MONITOR
630
TC CONVERT
631
ORIGINAL TC
display
632
JUMPING TC
select
633
CHARA ORG TC
DISPLAY at dual
line mode
634
LAST ERROR LOG
NUMBER DISPLAY
124
Menu List
Setting
Function
[off]
Sets whether to display remaining time on the tape in
10min
superimposed character position.
on
off: Do not display remaining time.
10min: Display remaining time when it is 10 minutes or
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until this unit finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
enable
Sets whether or not to display playback signal status in
[disable]
superimposed character position.
enable: Displays playback signal status.
disable: Does not display playback signal status.
[off]
Selects whether to convert the playback time code to the
on
operating frequency time code when tapes recorded with
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
[off]
When item 630 is set to "on," this setting specifies whether
on
the 24-frame time code is displayed or not on the control
panel of this unit before conversion.
off: The 24-frame time code is not displayed before
on: The 24-frame time code is displayed before conversion.
Sets the loopback point (JUMPING TC) for converting time
code with respect to the reference time code (STARTING
–2H
TC) for conversion.
–1H
–3H: The JUMPING TC is set 3 hours before STARTING
+1H
+2H
–2H: The JUMPING TC is set 2 hours before STARTING
+3H
0H
–1H: The JUMPING TC is set 1 hour before STARTING TC.
+1H: The JUMPING TC is set 1 hour after STARTING TC.
+2H: The JUMPING TC is set 2 hours after STARTING TC.
+3H: The JUMPING TC is set 3 hours after STARTING TC.
0H: The JUMPING TC is set 1 frame before STARTING TC.
[off]
Selects whether to display the time code of the playback
on
tape (original time code) in addition to the converted time
code, when time code has been converted and menu item
626 is set to anything other than "time data only".
off: The original time code is not displayed.
on: The original time code is displayed.
The original time code appears in the second line when you
set this item set to "on".
[off]
Sets whether or not the number of error messages appears
on
in a superimposed character display.
blink
off: The number of error messages is not displayed.
on: The number of error messages is displayed.
blink: The number of error messages is displayed. When a
less.
conversion.
The type of time code displayed is specified by item
603.
TC.
TC.
new error is detected, the number flashes.
Advertisement
Table of Contents
