Table of Contents
Advertisement
Quick Links
SG & EG 600-700-780-900-1100 twin burner only
Pure
Grate
Fire and flue system installation, and instructions to comply with NZS 5601.1:2013,
3645.1(Int):2010, 3645.2(Int):2010, 5266:2014, 2918:2001.
The fireplace is constructed and tested to comply with NZS 4558(int):2013 "Decorative gas log and other fuel effect appliances".
Keep these instructions for further reference. Ensure that you have the correct and current installation details for the Warmington fireplace.
The Warmington unit is to be installed by a certified Warmington installer or an approved NZHHA installation technician.
A licenced certified gas fitter and licenced electrician are required to run power and gas supplies as required to the unit and any commissioning as part of the
installation process.The heater must be installed according to these instructions and in compliance with all relevant building, gas fitting, electrical and other
Read all the instructions carefully before commencing the Installation. Failure to follow these instructions may result in a fire hazard and void the warranty
1
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
Installation Guide Only
Traditional
Related documents
See www.homeheat.co.nz/members for a certified NZHHA SFAIT Installer in your area.
Burner Only
Installation
statutory regulations.
IMPORTANT
All Dimension are in mm
29 March 2021
Classic Grate
Advertisement
Table of Contents
Related Manuals for Warmington SG-EG 600 Twin
Summary of Contents for Warmington SG-EG 600 Twin
- Page 1 The fireplace is constructed and tested to comply with NZS 4558(int):2013 “Decorative gas log and other fuel effect appliances”. Keep these instructions for further reference. Ensure that you have the correct and current installation details for the Warmington fireplace. Installation The Warmington unit is to be installed by a certified Warmington installer or an approved NZHHA installation technician.
- Page 2 Require to be serviced by Certified Gasfitter annually. NOTE: See “IMPORTANT INFORMATION FROM THE STANDARD” in this specification. These requirements are mandatory Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
-
Page 3: Important Notes
HEARTH CLEARANCES Note: For Combustible Floors Minimum Hearth of 300mm (H) must be maintained at any given height. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm... - Page 4 The appliance and flue system must be tested in accordance with the relevant and current standards and the appropriate building codes. FLUED GAS APPLIANCES All Gas Fires requiring Warmington Flue Systems shall be Installed to the requirements of the current standards and shall be appropriately designed and constructed to permit safe and effective use.
-
Page 5: Bottom Row
Bottom Total SG/EG 600 Twin SG/EG 700 Twin SG/EG 780 Twin SG/EG 900 Twin SG/EG 1100 Twin Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm... - Page 6 Installation to comply with current standards. When installing a fitted open gas fire with an existing chimney section 6.7.11 in NZS 5601 is particularly relevant, see quote below: Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
-
Page 7: To Shut Down
Turn control switch to 'PILOT'. Flame bed will extinguish. Pilot light may be left running or extinguished by switching to 'OFF' before closing cover. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm... - Page 8 Replace the Base screw and check for leaks. 3 Flame Pilot in Assembled State Correct Operation of 3 Flame Pilot Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 9 Installation to comply with current standards. When installing a fitted open gas fire with an existing chimney section 6.7.11 in NZS 5601 is particularly relevant, see quote below: Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 10 . Use a standard screw driver. WARNING: Ensure that the dust cap is replaced after adjustment Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 11 Replace the Base screw and check for leaks. 3 Flame Pilot in Correct Operation of 3 Flame Pilot Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 12 29 March 2021 ON/OFF SWITCH (SIT 840) - WIRING DIAGRAM Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 13 Installation to comply with current standards. When installing a fitted open gas fire with an existing chimney section 6.7.11 in NZS 5601 is particularly relevant, see quote below: Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 14 WARNING: To ensure the Correct Operation of the Hi/Low burner it is necessary that the Plastic Cap is returned to its original location . Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 15 Replace the Base screw and check for leaks. 3 Flame Pilot in Correct Operation of 3 Flame Pilot Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 16 29 March 2021 HIGH/LOW SWITCH (SIT 845) - WIRING DIAGRAM Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 17 Installation to comply with current standards. When installing a fitted open gas fire with an existing chimney section 6.7.11 in NZS 5601 is particularly relevant, see quote below: Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
-
Page 18: Remote Control Features
At any time, the temperature may be adjusted up or down. However, whenever the remote changes to a new time period, the temperature will be set automatically according to that period’s setting. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm... - Page 19 OFF state display. During this time a special code will be transmitted by the RF Remote to the Control Unit, causing the Control Unit to learn its ID. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
-
Page 20: App Operation
Google Play Store: https://play.google.com/store/apps/details?id=com.millec.intelligythermostatmkii For instructions on how to push the appliance to your Wi-Fi, please go to the Warmington website and find details located under the ‘Downloads’ tab for your fireplace model. The app has both manual control and automatic controls. - Page 21 This controller can not adjust flame height, hence is supplied for emergency use, if remote and phone App is not able to be used. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 22 WARNING: To ensure the Correct Operation of the Modulator it is necessary that the Plastic Cap is returned to its original location . Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 23 Replace the Base screw and check for leaks. 3 Flame Pilot in Correct Operation of 3 Flame Pilot Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 24 29 March 2021 FULLY MODULATING (SIT 845) - WIRING DIAGRAM Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...
- Page 25 29 March 2021 POINTS OF SAFETY—To the Customer /Home-Owner Your Warmington Gas Decorative Burner operates on the principle of dual radiant and convected heat. Therefore it is important to observe the following precautions associated with any heating appliance or open fire.
-
Page 26: General Notes
NOTE: Keep a copy of these instructions for operating and maintenance guidelines. Industries 1994 LTD PO Box 58652, Botany 2163, Auckland www.warmington.co.nz Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All Dimension are in mm...