Motorola Commercial Series Basic Service Manual page 81
Hide thumbs
Also See for Commercial Series:
- Basic user's manual (86 pages) ,
- Basic service manual (74 pages) ,
- Selling manual (66 pages)
Table of Contents
Advertisement
Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 7-13
Note: Ensure that the plug orientation is correct with the exposed pins in the wire casing facing
upward and fully plugged in.
a.
Connect the speaker wire assembly into the 2-pin connector on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
b.
Connect the microphone wire assembly into the two hole socket on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
c.
Slide the audio jack shroud onto accessory connector
2. Position the radio
connector located on the bottom of the main board, pushing up the 2 end tabs.
3. Slide the volume potentiometer and frequency switch shafts into their respective holes in the front
cover. Look through the accessory connector opening to make certain that the wires are not
pinched, between the shroud and housing.
68009328001-A
(Figure
7-17).
(Figure
7-17).
Microphone
Connector
Figure 7-17. Microphone and Speaker Re-assembly
(Figure
7-18) and reconnect the flex cable connector from the keyboard into the
Figure 7-18. Keyboard Flex Cable Connection
(Figure
7-17).
Speaker Connector
Radio Chassis
End Tabs
Flex Connector
December, 2009
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
