Table of Contents
Advertisement
Check item
Finisher
Transport sensor (S2)
Finisher controller board
Replace parts
Transport sensor (S2)
Finisher controller board
[EA32] Exit paper remaining jam
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Finishing tray paper detection sensor
(S12)
Finisher controller board
Replace parts
Finishing tray paper detection sensor
(S12)
Finisher controller board
[EA40] Door open jam
Classification
Finisher jam
(Finisher section)
Check item
Cover
Front cover switch (SW1)
Stationary tray opening/closing
switch (SW2)
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
•
Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
•
Sensor check
•
Connector check
•
Harness check
•
Connector check(CN11)
•
Board check
The paper is remaining on the finishing tray when the power
is turned ON. [MJ-1103/1104]
•
Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
•
Sensor check
•
Connector check
•
Harness check
•
Connector check(CN11)
•
Board check
The front cover or stationary tray cover is opened during
paper transport. [MJ-1103/1104]
•
Close the front cover or the stationary tray cover if they are
opened.
•
Sensor check
•
Connector check
•
Harness check
•
Sensor check
•
Connector check
•
Harness check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 93
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
ERROR CODE and TROUBLESHOOTING
8
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
