Restore Settings - GE T60 Instruction Manual
Transformer protection system
Hide thumbs
Also See for T60:
- Instruction manual (796 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (718 pages)
Table of Contents
Advertisement
CHAPTER 10: MAINTENANCE
To save list of sites and devices with an Environment backup:
1.
In EnerVista, click File > Environment > Backup. A window opens.
2.
Name and save the .ENV file.
10.6.2 Restore settings
UR device settings can be restored to the values they were at when a URS backup file was created using the EnerVista UR
Setup software. When the IEC 61850 option is present, the settings can alternatively be to the values they were at when an
IID type backup was created either using the EnerVista UR Setup software in online mode or by using any of the supported
file transfer protocols. Note that TFTP cannot be used here, as TFTP "put" mode is disabled for security reasons.
To restore completely, a few settings need to be entered manually either via EnerVista UR Setup or via the UR device front
panel. If the restore operation is to be via Ethernet, first the UR device must have its IP address settings entered via the
front panel. These are located at
PRODUCT SETUP COMMUNICATIONS IPv4 ROUTE TABLE 1(6) DEFAULT IPv4 ROUTE GATEWAY ADDRESS
When importing a file, it cannot have a blank numeric value. All numeric values must be non-blank, otherwise the file is
rejected.
URS and IID procedures are outlined here.
To restore settings from a URS file:
1.
In EnerVista, connect to the device in the Online Window area.
2.
Right-click the .urs file in the Offline Window area and select Add Device from File to locate a file, and/or drag-and-
drop the file from the Offline Window area to the device in the Online Window area.
3.
Two prompts are possible, first that the URS file does not include the complete IEC 61850 configuration and that it
needs to be recreated if you continue. This means that the URS file is from UR version 7.30 or higher, has the IEC 61850
software option in the order code, but any IEC 61850 content will be compromised and will need to be configured.
T60 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
SETTINGS PRODUCT SETUP COMMUNICATIONS NETWORK 1(3)
Figure 10-7: Restoring a URS settings file
BACK UP AND RESTORE SETTINGS
and
SETTINGS
.
10-9
10
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
