Removing A 3.5-Inch Hot Swappable Hard Drive Adapter From A 3.5-Inch Hot Swappable Hard Drive Carrier - Dell PowerEdge R430 Owner's Manual
Hide thumbs
Also See for PowerEdge R430:
- Owner's manual (188 pages) ,
- Getting started (2 pages) ,
- Owner's manual (155 pages)
Table of Contents
Advertisement
Figure 35. Installing a hot swappable hard drive carrier
1.
release button
3.
hard drive carrier handle
Next steps
If removed, install the front bezel.
Related Links
Safety instructions
Removing the optional front bezel
Installing a hard drive into a hard drive carrier
Installing the optional front bezel
Removing a 3.5-inch hot swappable hard drive adapter from a 3.5-inch hot
swappable hard drive carrier
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Follow the safety guidelines listed in safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
If installed, remove the front bezel.
Steps
1.
Remove the 3.5-inch hot swappable hard drive carrier from the system.
2.
Remove the screws from the rails on the hot swappable hard drive carrier.
3.
Lift the 3.5-inch hard drive adapter out of the 3.5-inch hot swappable hard drive carrier.
2.
hard drive carrier
107
Advertisement
Table of Contents
Troubleshooting
