Page 2
EMC Directive issued by the provide reasonable protection against Commission of the European Community. harmful interference in a residential The manufacturer of this product is Sony installation. This equipment generates, Corporation, 1-7-1 Konan, Minato-ku, uses, and can radiate radio frequency Tokyo, Japan.
Table of Contents Features ..................4 Parts Identification ..............4 Front/Top/Right Sides .............4 Left Side ................6 Using a Battery ...............7 Inserting the Battery ............7 Removing the Battery ............8 Attachment and Connections ..........8 Attaching the Receiver/Tuner Unit ........8 To Connect the Power Cable ...........9 To Connect the Audio Cables ..........9 On Connecting Word Clock Sync Signal and Digital Audio Signal ............9...
Sony camcorders. In combination with the 1 2 3 DWR-S01D or WRR-855S, the DWA-F01D can also work as a portable wireless receiver. Wide array of audio output To draw its full performance, the DWA-F01D comes equipped with a wide range of interfaces.
Page 5
For details on how to attach the receiver or tuner unit to the DWA-F01D, see “Attaching the Receiver/ receiver is turned off. Tuner Unit” on page 8.
For details on the frequency of the sync signal, refer Left Side to the Operating Instructions supplied with the DWR-S01D. Note Even when the 75-ohm termination has been added on the DWR-S01D, this connector still works as the high-impedance input connector while the DWR-S01D is turned off.
e OUTPUT 1/2 connector (3.5-mm Using a Battery TRS jack, tip: L, ring: R, sleeve: GND) Connects to headphones or portable recorders. The tuner audio of the OUTPUT 1 and Inserting the Battery OUTPUT 2 connectors is output from the left and right channels respectively.
Removing the Battery Attachment and Slide the battery out while holding down Connections the battery stopper in the direction of the arrow. Attaching the Receiver/ Tuner Unit Insert the DWR-S01D or WRR-855S into the wireless receiver slot. Insert the receiver/tuner unit into the wireless receiver slot after observing the direction of the D-sub 15-pin connector inside the slot and that of the...
Sync Signal and Digital Audio Signal The DWR-S01D attached to the DWA-F01D and the device connected to the DWA-F01D through the digital audio interface can be operated properly, under either of the following conditions: • The device that is connected to the...
If you encounter a problem using this adapter, use the following checklist to find a solution. For any problems with the transmitter or receiver, refer to the operating instructions of the respective device. If the problem persists, consult your Sony dealer. Symptom...
Page 12
Symptom Meanings Remedy A battery is inserted, The battery is fully Recharge the battery. but the indicator discharged. does not light. The power switch on the The indicator is designed to light in receiver is turned off. accordance with the power switch on the receiver.
Operation communication devices The use of portable telephones and other communication devices near the DWA-F01D may result in malfunction and interference with audio signals. It is Notes on Using the recommended that portable Adapter communication devices near the DWA-F01D be turned off.
7.2 V DC (battery) Always verify that the unit is operating Operating voltage properly before use. SONY WILL NOT 10 V DC to 17 V DC (DC IN) BE LIABLE FOR DAMAGES OF ANY 6 V DC to 8.4 V DC (battery)