Related Manuals for Makita DTD134
Summary of Contents for Makita DTD134
- Page 1 INSTRUCTION MANUAL Cordless Impact Driver DTD134 DTD146 012010 IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model DTD134 DTD146 Machine screw 4 mm - 8 mm Capacities Standard bolt 5 mm - 14 mm High tensile bolt 5 mm - 12 mm No load speed (min 0 - 2,400 0 - 2,300... - Page 3 Do not abuse the cord. Never use the cord for 18. Do not use the power tool if the switch does carrying, pulling or unplugging the power tool. not turn it on and off. Any power tool that cannot Keep cord away from heat, oil, sharp edges or be controlled with the switch is dangerous and moving parts.
- Page 4 29. Follow instruction lubricating A battery short can cause a large current flow, changing accessories. overheating, possible burns and even a 30. Keep handles dry, clean and free from oil and breakdown. grease. Do not store the tool and battery cartridge in GEB054-1 locations where the temperature may reach or exceed 50 ﾟ...
-
Page 5: Functional Description
When the tool is overloaded: • FUNCTIONAL DESCRIPTION At this time, release the switch trigger, remove the battery cartridge and remove causes of overload and then pull the switch CAUTION: trigger again to restart. Always be sure that the tool is switched off and the •... - Page 6 NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. • LED indicator status Remaining battery capacity Be careful not to scratch the lens of lamp, or it may lower the illumination. Reversing switch action About 50% or more 1.
-
Page 7: Operation
For tool with deep bit hole Hook 1. Hook A=17mm 2. Screw To install these types of bits, follow the procedure (1). B=14mm To install these types of bits, follow A=12mm the procedure (2). B=9mm (Note) Bit-piece is necessary for installing the bit. -
Page 8: Maintenance
The manner of holding the tool or the material of High tensile bolt driving position to be fastened will affect the torque. Operating the tool at low speed will cause a (kgf cm) reduction in the fastening torque. (1,224) MAINTENANCE (M12) (1,020) CAUTION:... -
Page 9: Optional Accessories
Raise the arm part of the spring and then place it in the OPTIONAL ACCESSORIES recessed part of the housing with a slotted bit screwdriver of slender shaft or the like. CAUTION: 1. Carbon brush These accessories attachments • recommended for use with your Makita tool specified in this manual. - Page 12 Makita Corporation www.makita.com 885243B3...