Audio; Tuner; Tv Tuner; Dvd - Kenwood DDX6019 Service Manual
Monitor with dvd receiver
Hide thumbs
Also See for DDX6019:
- Instruction manual (88 pages) ,
- Installation manual (25 pages) ,
- Instruction manual (102 pages)
Table of Contents
Advertisement
DDX6019/6029/6029Y/6039
Audio
• Default volume is Step 30.
• Bal/Fad setting is changed among Min
each click.
• Line Mute default is On.
• Xover setting is changed between Min
• Tone setting is changed among Min
each click.
• Default Tone (EQ) value is Flat.
• Default system Q is OFF.
• When there is Digital Out terminal, the setting should al-
ways be output on setting.
• Sub Woofer default is ON (same in the normal mode).
Tuner
• When unable to access E2PROM, display "Error" (Tuner
screen).
• K3I forced switching among narrow/middle/wide.
Forced to narrow by pressing and holding Preset 4
: "
. 1MHz"
Forced to middle by pressing and holding Preset 5
: "
. 2MHz"
Forced to wide by pressing and holding Preset 6
: "
. 3MHz"
• Switch Tuner Span (K
+ Reset.
Span information is displayed on the Information screen.
BEEP control
• Beep regardless of the destination.
(While in Standby source, beep cannot be output because
of PWIC restriction.)
SI control
• Set SI default to On.
AVIF
• AVIN Interruption default shall be On.
• NAVI interruption SP setting default is FRONT ALL.
• V-IN mirror mode switching is done by Remote Control
Tenkey 3.
• R-CAM Interruption default shall be On.
SCREEN adjustment
• By pressing the remote control Tenkey 6 on each video
screen, each video screen's SCREEN adjustment items are
displayed.
20
TEST MODE
Center
Max by
Max by each click.
Center
Max by
M) with [SRC] key + [Vol. Dw] key
• The default is Center, and switch among Full Down
ter
Full Up by each click.
• BRT default is MAX.
TV tuner
• If the destination is E, set the TV2 default value to "Area 5
(Russia)", "Ch 8 (191.25MHz)". (When KTC-V500 is con-
nected.)
• If the destination is E, set the TV2 default value to "Area 4
(Russia)", "Ch 8 (191.25MHz)". (When KTC-V300 is con-
nected.)
(HPOSI adjustment mode shall be TV1.)
* If started up as above, even if the test mode is cancelled by
ACC/Power OFF
ON, the setting values are maintained
(set to default by Reset).
DVD
• CD media KTD-02A and DVD media TDV-540A/TTD-100
are used.
• If the test mode is started up with Disc loaded Panel Open
and in test mode, the disc is not ejected (same in normal
mode).
• Set region code at the position for the time code.
• When Loading, set to Title1-Chapter1 (Shown with
table below)
• CDDA audio checking (KTD-02A)
For CDDA audio checking
Track
1
-
9
-
15
-
10
-
11
-
12
-
13
-
14
-
9
-
RDM
For CDDA audio checking
Track
28
-
Cen-
in the
Track
Up/Dw
Hide quick links:
Advertisement
Table of Contents
