Operating Instructions Memory Card Drive Model No. AJ-PC D10 Connect the Memory Card Drive to a personal computer before installing the P2 driver to the computer from the installation CD. For details, refer to the Installation Manual. Before operating this product, please read the instructions carefully and save this manual for future use.
L or coloured RED. A replacement fuse cover can be purchased from your local Panasonic Dealer. How to replace the fuse 1. Open the fuse compartment with a screwdriver. IF THE FITTED MOULDED PLUG IS UNSUITABLE...
Page 4
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
Declaration of Conformity Model Number: AJ-PCD10P Trade Name: PANASONIC Responsible Party: Matsushita Electric Corporation of America One Panasonic Way, Secaucus, NJ 07094 Support contact: Panasonic Broadcast & Tlevision Systems Company 1-800-524-1448 This device complies with Part 15 of FCC Rules. Operation is subject to the following...
Overview The AJ-PCD10 (hereinafter referred to as “P2 drive”) is a data transfer device that uses a USB 2.0 interface and is designed only for AJ-P2C series memory cards (hereinafter referred to as “P2 card(s)”). The P2 drive enables high-speed transfer to a personal computer of clip data shot with a P2 card camera-recorder.
Parts and their Functions Front Panel Rear Panel DC IN 16V DC IN 12V USB 2.0 The picture shows the rear panel with its cover removed. (1) Power Indicator (1) USB 2.0 connector (Type B) This indicator lights up in green when This connects a USB cable.
Inserting a P2 Card When inserting a P2 card into the slot in the P2 drive, make sure you keep the card horizontal as you ease it in. Forcing the card in on an angle may cause a problem. Write-protection of P2 Card A P2 card has a write-protect switch.
To disconnect the USB cable, select “Safety Remove Hardware” from the system tray on the taskbar, de-activate [Panasonic P2 Series USB Device], then unplug the cable. Plug a USB 2.0 cable B connector into the USB connector on the P2 drive.
To Mount the P2 drive in a Personal Computer 5-inch Bay Turn OFF the personal computer’s <Note> power. USB 2.0 connector pinouts vary according to the type of motherboard type. Check Undo the six screws and remove the your computerís instruction manual before cover.
Specifications [Card slots] AC 100 V - 240 V, 0.8 A - 0.4 A, 50 - 60 Hz (AC adapter input) PC card Type II a 5 (CardBus compliant) DC 16 V, 0.8 A (when used with AC adapter) Please note that specifications and DC 12 V, 1.0 A appearance are subject to change, for (when mounted in a personal computer)
Page 12
PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY UNIT COMPANY OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA Executive Office: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7000 EASTERN ZONE: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Southeast Region: 1225 Northbrook Parkway, Ste 1-160, Suwanee, GA 30024 (770) 338-6835...