Table of Contents
Advertisement
5 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
6 Close the system. See "Closing the System" on page 70.
7 Place the system upright and on its feet on a flat, stable surface.
8 Reattach any peripherals, then connect the system to the electrical outlet.
9 Turn on the system and attached peripherals.
Installing the Expansion Card Shroud
1 Insert the rear shroud alignment tabs into the rear shroud tab slots, and
then lower the shroud into the chassis. Align the front shroud alignment
tab with the front shroud tab slot, and press downward on the shroud to
lock the latch into place. See Figure 3-6.
2 Close the system. See "Closing the System" on page 70.
3 Place the system upright and on its feet on a flat, stable surface.
4 Reattach any peripherals, then connect the system to the electrical outlet.
5 Turn on the system and attached peripherals.
Power Supplies
Depending on your configuration, your system supports up to two hot-
pluggable redundant power supplies rated at 675 W, or a single
non-redundant power supply rated at 650 W.
If your system has redundant power supplies, see "Removing a Redundant
Power Supply" on page 76 or "Installing a Redundant Power Supply" on
page 77. If your system has a non-redundant power supply see "Removing a
Non-redundant Power Supply" on page 78 or "Installing a Non-redundant
Power Supply" on page 81.
If two redundant power supplies are installed, the second power supply
provides power redundancy. In redundant mode, the system distributes the
power load across both power supplies to maximize efficiency. When a power
supply is removed with the system powered on, the full power load is picked
up by the remaining power supply.
Installing System Components
75
Advertisement
Table of Contents
Troubleshooting
