Table of Contents
Advertisement
Chapter 3
Installing the Content Engine
Installing the Chassis on a Tabletop
Step 1
Step 2
Step 3
Step 4
OL-5756-01
Download from Www.Somanuals.com. All Manuals Search And Download.
Leave enough slack in the cables to allow for sliding the Content Engine
Note
in or out of the rack.
To remove the Content Engine from the rack, reverse these instructions. Store
these installation instructions with your Content Engine documentation for
future use.
When you install a Content Engine on a workbench or tabletop, ensure that the
surface is clean and in a safe location and that you have considered the following:
The chassis should be installed off the floor. (Dust that accumulates on the
•
floor is drawn into the interior of the chassis by the cooling fans. Excessive
dust inside the Content Engine can cause overtemperature conditions and
component failures.)
There must be approximately 19 inches (48.26 cm) of clearance at the front
•
and rear of the chassis for accessing network cables or equipment.
The Content Engine must receive adequate ventilation (it is not being
•
installed in an enclosed cabinet where ventilation is inadequate).
Follow these steps to install the Content Engine on a workbench or tabletop:
Remove any debris and dust from the tabletop or workbench, as well as from the
surrounding area. Also make sure that your path between the Content Engine and
its new location is unobstructed.
Attach the rubber feet to the bottom of the chassis. The rubber feet have an
adhesive backing. Peel the protective tape off the adhesive and stick the feet to the
bottom of a clean chassis surface. Place one foot in each corner.
Place the chassis on the tabletop or workbench.
Ensure that no exhaust air from other equipment will be drawn into the chassis.
Also, ensure that there is adequate clearance at the front and rear of the chassis.
Cisco Content Engine 511 and 566 Hardware Installation Guide
Installing a CE-511 or CE-566 Unit
3-11
Advertisement
Table of Contents
Troubleshooting
