Advertisement
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Warning!
instructions
automatic
start-up
This product is only suitable for well insulated spaces or occasional use.
1. SAFETY
1.1.
ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
‰
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You
must also read and understand the following instructions concerning electrical safety.
Ensure that cables are always protected against short circuit and overload.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections
9
to ensure that none are loose.
Ensure that the voltage marked on the appliance matches the power supply to be
9
used and that the plug is fitted with the correct fuse - see fuse rating at right.
DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or
8
replaced immediately by a competent electrician.
It is recommended that this heater is wired directly to a fused isolator switch. If, however, a plug
9
is fitted, the following applies:
Fit a new plug according to the following instructions (UK only).
9
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected,
that the cable restraint is tight.
1.2.
GENERAL SAFETY
Read instructions carefully. read and follow all instructions. Place instructions in a safe place for future reference.
9
WARNING! your safety is important to you and to others, please read these instructions before you operate this heater.
‰
DO NOT allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
8
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss
of life.
A qualified installer is required to install, adjust and, where necessary, convert the appliance for use with other fuel types. Consult the
9
appliance manufacturer before replacing parts other than those specified or recommended in the servicing instructions.
Service must be performed by a qualified service agency.
9
Unvented portable heaters use air (oxygen) from the area in which it is used. Adequate combustion and ventilation air must be
9
provided. Refer to instructions.
Check that the heater is in sound condition and good working order. Servicing must be performed by qualified operatives only.
9
Take immediate action to repair or replace damaged parts. Use recommended parts only. Unapproved parts may be dangerous and
will invalidate the warranty.
Only use clean kerosene or diesel (NOT BIO-DIESEL) to fuel your heater, in accordance with instructions contained in this manual.
9
WARNING! DO NOT store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance.
‰
WARNING! fire, burn, inhalation, and explosion hazard. keep solid combustibles, such as building materials, paper or cardboard, a
‰
safe distance away from the heater as recommended by the instructions. Never use the heater in spaces which do or may contain
volatile or airborne combustibles, or products such as gasoline, solvents, paint thinner, dust particles or unknown chemicals.
WARNING! DO NOT store or use compressed air cylinders, petrol or other flammable liquids/gases in the vicinity of this or any other
‰
appliance.
WARNING! Only use heater in well ventilated areas. Ensure continuous ventilation from outside of the building is provided to the
‰
heater operating area. Refer to 5.2 Installation Maximum Opening Size.
Unvented portable heaters use air (oxygen) from the area in which it is used. Adequate combustion and ventilation air must be
provided.
WARNING! Indirect-fired heaters may cause carbon monoxide (CO) poisoning when incorrectly used, e.g indoors without adequate air
‰
circulation, or if not properly working. CO poisoning may lead to death.
© Jack Sealey Limited
102,000BTU/HR INDIRECT SPACE WARMER®
KEROSENE/DIESEL HEATER WITH WHEELS
ABI1000
MODEL NO:
Warning!
Warning!
Hot surfaces
Original Language Version
Recommended fuse rating
13 Amp
ABI1000 Issue: 1 19/07/23
Advertisement
Table of Contents
Related Manuals for Sealey ABI1000
Summary of Contents for Sealey ABI1000
- Page 1 ABI1000 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 2: Specification
Indirect fired heaters are sophisticated, reliable, and highly efficient heaters. Ideal for places where there’s limited ventilation, or where people are present, as they deliver huge volumes of clean, dry, fume free heat safely and economically. The Sealey 102,000Btu/hr Indirect Space Warmer® has a 30kW heat output ideal for heating marquees, events, halls, workshops, warehouses, construction sites and more. -
Page 3: Installation
Fill tank with clean fuel. Only use Diesel or Kerosene. There is a fuel gauge on the top of the tank which allows you to check the fuel level.. 6.2. For indirect fired heaters: connect the heater to a chimney or to an exhaust duct. To get a proper draught in the chimney the exhaust gas path must rise. Avoid any elbows and bends in the first part of the exhaust ducts for at least 3m, fig.2. Original Language Version © Jack Sealey Limited ABI1000 Issue: 1 19/07/23... -
Page 4: Maintenance
FUEL FILTERS 7.7.1. Clean fuel filters by unscrewing the filter tray (clockwise) Remove the filter cartridge and wash it with petrol or replace it if necessary. Check seal O-ring and replace it if necessary. Reassemble the tray, fig.3. The fuel filter installed on the gear pump should be cleaned or replaced if necessary by unscrewing cap H, fig.4. fig.4 fig.5 Nozzle fig.3 7.8. EXTRACT THE BURNER HEAD WHIRL DISC 7.8.1. Clean the whirl disc (fig.5) using a brush and then blow compressed air on it. To get good combustion the air flow openings in the whirl disc should be perfectly clean and free. 7.8.2. NOZZLE Carefully unscrew nozzle from nozzle fitting, blow compressed air through nozzle orifice to free it from dirt. Replace nozzle if necessary, fig.5. ABI1000 Issue: 1 19/07/23 Original Language Version © Jack Sealey Limited... -
Page 5: Troubleshooting
E1 displayed on the screen Lock -out of appliance due to previous Detect the cause of overheating overheating Shut the appliance down Check air inlet and outlet Wait a few minutes and restart the appliance ABI1000 Issue: 1 19/07/23 Original Language Version © Jack Sealey Limited... -
Page 6: Weee Regulations
Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk... - Page 7 Unit The seasonal space heating Energy efficiency in active mode ƞ s,on The seasonal space heating energy efficiency ƞ ƞ Energy efficiency classes Contact details: Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk, IP32 7AR. www.sealey.co.uk ERP Table 1...