Table of Contents
Advertisement
Attaching the Sensor Module
For SQ2H series, attaching the supplied sensor module
allows you to use the sensor function.
Note
●
When attaching/removing the sensor module, be sure
to turn off the power of the display.
1
Connect the 4-pole micro plug cable
(supplied) to the sensor module.
Note
●
Firmly insert the terminal of the 4-pole micro plug
cable to the innermost.
Sensor module
2
Remove the release paper from one
side of the double-sided tape, and
attach the tape to the upper surface or
bottom surface of the sensor module.
Note
●
Wipe off dust, water, oil and other dirt on the
attaching surface, and affix the tape on the
attaching surface by pressing it firmly.
●
Once the double-sided tape is affixed, it cannot be
reused. Be sure to confirm the attaching position
before affixing it.
●
It is not guaranteed that the sensor module
is permanently fixed with the double-sided
tape. If it comes off due to an external force or
environmental conditions, fix the sensor module
with a commercially sold double-sided tape again.
Release paper
Double-sided
tape
16
English
4-pole micro plug cable
3
Remove the release paper from the
other side of the double-sided tape,
and attach the sensor module to the
bezel of the display.
Note
●
Attach it on the location where the front surface
of the sensor is able to detect the environmental
illuminance and an approaching hand.
●
When using the proximity sensor function, keep the
sensor module at least 2 cm away from the floor, desk
and ceiling. Also, do not place any object within 1 m
from the front surface of the sensor.
●
Wipe off dust, water, oil and other dirt on the
attaching surface, and affix the tape on the
attaching surface by pressing it firmly.
●
Once the double-sided tape is affixed, it cannot be
reused. Be sure to confirm the attaching position
before affixing it.
Example of sensor mounting location:
4
Connect the other terminal of the
4-pole micro plug cable to the
SENSOR IN terminal.
Note
●
Firmly insert the terminal of the 4-pole micro plug
cable to the innermost.
●
Fix the connection cable to the unit using the
supplied clamper to prevent it from sagging or
getting pulled casually. (see page 23 "Cable
fixing")
4-pole micro
plug cable
Advertisement
Table of Contents
