Table of Contents
Advertisement
4.3
Establish local communication
Connect the laptop to the USB or Ethernet ports to establish initial local communication. These ports are
configured at the factory for local operator access. Configure PCCU to use any of these ports.
–
To use USB, see section
–
To use Ethernet, see section
IMPORTANT NOTE: External weatherproof local communication connectors (USB or Ethernet) are
available on XCORE enclosures, if purchased. Use external ports to connect locally if the XIO is
inside an enclosure. If the XIO is a standalone device, use the USB or Ethernet ports.
Do not use external enclosure connectors for permanent field connections. These connectors are
only for local access during configuration or maintenance.
4.3.1
Using the USB port
The following instructions apply to USB port connections.
to connect to the USB port.
Table 4-1: USB cabling
Host system
interface type
USB 2.0 Type A
receptacle
To set up communication using the USB port:
38 | XIO USER MANUAL | 210 6424MNAB
4.3.1 Using the USB port
4.3.2 Using the Ethernet ports
Required cabling termination (connectors) or
adaptors
USB 2.0 Type mini-B plug to USB 2.0 Type A plug cable
(referred as USB PCCU32 cable)
Table 4-1: USB cabling
provides cabling details
ABB part number
1801800-xxx
Advertisement
Table of Contents
