SRF-HM01V TABLE OF CONTENTS Notes on chip component replacement • Never reuse a disconnected chip component. • Notice that the minus side of a tantalum capacitor may be dam- GENERAL ..............3 aged by heat. DISASSEMBLY Flexible Circuit Board Repairing 2-1.
SRF-HM01V SECTION 1 This section is extracted from instruction manual. GENERAL POWER ON/OFF Battery compartment lid Hook (L, R) Hang the hooks on your ears. Neckband Neckband (Left) TV/WB/FM SENS DX/LOCAL Driver Unit (Right) TUNE +* /– VOL* Display Light reflector (R, L)
SRF-HM01V SECTION 2 DISASSEMBLY • This set can be disassembled in the order shown below. 2-1. DISASSEMBLY FLOW 2-2. Microcomputer Board 2-4. Battery Board (Page 4) (Page 5) 2-3. MAIN Board (Page 5) 2-5 . Putting the Sheet (A) (Page 6) Note: Follow the disassembly procedure in the numerical order given.
SRF-HM01V 2-3. MAIN BOARD Note: When installing MAIN board, fit lever (A) and switch (S1). 2 claw lever (A) 2 claw 3 MAIN Board 1 Remove nine solders. 2-4. BATTERY BOARD Note: When installing BATTERY board, 1 four screws fit lever (A) and switch (S401).
SRF-HM01V 2-5. PUTTING THE SHEET (A) Put the sheet (A) positioning its corner to the corner of C26 in the main board so that the pin of CF2 is completely covered. main board...
SRF-HM01V SECTION 3 ELECTRICAL ADJUSTMENTS 0 dB=1 µV AM VCO VOLTAGE ADJUSTMENT Adjustment Part Frequency Display Reading on Digital Voltmeter [AM] 1.30 ± 0.05 V 530 kHz Setting: 8.10 ± 1.00 V Confirmation 1710 kHz BAND: AM AM TRACKING ADJUSTMENT...
SRF-HM01V SECTION 4 DIAGRAMS 4-1. BLOCK DIAGRAM – TUNER Section – SIGNAL PATH : FM/TV (2 − 6ch) AM BAND SWITCHING : TV (7 − 13ch) /WEATHER 10.7MHz : AM FM WIRE ANTTENA FM RF IN TV/FM/WB FM MIX 10.7MHz...
SRF-HM01V 4-4. PRINTED WIRING BOARD – MAIN Board (Component Side) – FM WIRE ANTENNA BATTERY BOARD (Page 14) MAIN BOARD (COMPONENT SIDE) (HEADPHONE) R106 R113 E C B E C B C115 R117 R116 R105 E C B C106 • Semiconductor...
SRF-HM01V 4-11. IC PIN FUNCTION DESCRIPTION • MICROCOMPUTER BOARD IC301 TC9329FA-112 (SYSTEM CONTROLLER) Pin No. Pin Name Description 1 to 4 COM1 to COM4 Common drive signal output to the liquid crystal display 5 to 15 S1 to S11 Segment drive signal output to the liquid crystal display...
SRF-HM01V SECTION 5 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they may have some difference from the original are seldom required for routine service. Some one. delay should be anticipated when ordering •...
SRF-HM01V 5-2. BOARD SECTION micro computer board LCD1 main board Note: Refer to “2-5. Putting the Sheet (A)” (page 6) for the place to put the sheet (A). Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark...
SRF-HM01V SECTION 6 BATTERY MAIN ELECTRICAL PARTS LIST NOTE: When indicating parts by reference • Due to standardization, replacements in the • Items marked “*” are not stocked since they number, please include the board. parts list may be different from the parts speci- are seldom required for routine service.
Page 25
SRF-HM01V MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 1-216-845-11 METAL CHIP 100K 1/10W < CERAMIC FILTER > 1-216-845-11 METAL CHIP 100K 1/10W 1-216-845-11 METAL CHIP 100K 1/10W 1-767-313-11 FILTER, CERAMIC (10.7MHz) 1-216-833-11 METAL CHIP...
Page 28
SRF-HM01V REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision...