Advertisement
Available languages
Available languages
Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecallthe pressure
washerhelp{ine at 1-800-222-3136.
IMPORTANT: Anyattempt t o runtheenginebefore it
hasbeenserviced withthe recommended oilwill result
in anengine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
•
Open carton and slice two corners from top to
bottom so the panel can be folded down flat.
•
Remove fillers, accessories and parts bag shipped
with your pressure washer.
•
Remove the pressure washer out the open end of
the carton.
•
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Turbo nozzle
Wheel kit
Safety goggles
Engine oil
Parts bag (which includes items listed below)
Owner's manual
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1.
Attach handle to main unit.
2.
Install wheel kit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
6.
Connect water supply to pump.
Attach
Handle
1.
Place plastic adapters in hinges on handle
extension as shown.
NOTE: Make sure lip on plastic adapters is facing up
in hinges.
2.
Clamp handle extension onto pressure washer
handle and insert T-bolts into holes of clamp.
Tighten by hand.
"-\ ............
7/
/
/,
j..
f
\\
i /
_nstaH Wheem Kit
The wheel kit is designed to greatly improve the
portability of your pressure washer.
NOTE: Wheel kit is not intended for over-the-road use.
Install the wheel kit as follows:
1.
Place the bottom of the pressure washer frame on a
flat, even surface, such as blocks to ease assembly.
2.
Spread axle brackets apart and place over front
vibration mounts on the pressure washer frame as
shown.
\
\
.
Squeeze axle brackets back to original shape.
\
\
\
\
Advertisement
