Additional Information; Troubleshooting - Sony STR-DE345, STR-DE245 Operating Instructions Manual
Sony operating instructions fm stereo fm-am receiver str-de345,str-de245
Hide thumbs
Also See for STR-DE345, STR-DE245:
- Operating instructions manual (84 pages) ,
- Dimensions (1 page) ,
- Service manual (32 pages)
Table of Contents
Advertisement
Available languages
Available languages
Additional Information
Troubleshooting
If you experience any of the following difficulties while
using the receiver, use this troubleshooting guide to
help you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.
There's no sound or only a very low-level sound is heard.
/ Check that the speakers and components are
connected securely.
/ Make sure you select the correct component
on the receiver.
/ Make sure you set the SPEAKERS button to
ON.
/ Press MUTING if the MUTING indicator
turns on.
/ The protective device on the receiver has been
activated because of a short circuit
("PROTECT" flashes). Turn off the receiver,
eliminate the short-circuit problem and turn
on the power again.
The left and right sounds are unbalanced or reversed.
/ Check that the speakers and components are
connected correctly and securely.
/ Adjust the balance (see page 10).
Severe hum or noise is heard.
/ Check that the speakers and components are
connected securely.
/ Check that the connecting cords are away
from a transformer or motor, and at least 10
feet (3 meters) away from a TV set or
fluorescent light.
/ Place your TV away from the audio
components.
/ Make sure you connect a ground wire to the
antenna ground terminal.
/ The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with alcohol.
No sound is heard from the center speaker.
/ Select the appropriate center mode (see page
16).
/ Adjust the speaker volume appropriately (see
page 17).
Additional Information
No sound or only a very low-level sound is heard from
the rear speakers.
/ Select the appropriate center mode (see page
16).
/ Adjust the speaker volume appropriately (see
page 17).
/ Make sure you turn on the sound field
surround mode function.
Radio stations cannot be tuned in.
/ Check that the antennas are connected
securely. Adjust the antennas and connect an
outdoor antenna if necessary.
/ The signal strength of the stations is too weak
(when you tune in with automatic tuning).
Use direct tuning.
/ Make sure you set the tuning interval
correctly (when you tune in AM stations with
automatic tuning) (see pages 12 and 20).
/ No stations have been preset or the preset
stations have been cleared (when you tune in
with scanning preset stations). Preset the
stations (see page 13).
Surround effect cannot be obtained.
/ Make sure you turn on the sound field
function.
/ Make sure that the SPEAKERS button is
depressed.
No picture or an unclear picture is seen on the TV screen.
/ Select the appropriate function on the
receiver.
/ Place your TV away from the audio
components.
Recording cannot be made.
/ Check that the components are connected
correctly.
/ You cannot record audio from a program
source connected to the 5.1 CH/DVD jacks.
The remote does not function.
/ Point the remote at the remote sensor g on
the receiver.
/ Remove the obstacles in the path of the
remote and the receiver.
/ Replace both batteries in the remote with new
ones if they are weak.
/ Make sure you select the correct function on
the remote.
19
US
Hide quick links:
Advertisement
Chapters
Table of Contents
