Table of Contents
Advertisement
4
Parts Replacement and Clearning > Image Formation System > Removing the Side Seal
Removing the Side Seal
<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Primary Charging Assembly. (Refer to page 4-97)
3. Remove the Pre-transfer Charging Assembly. (Refer to page 4-108)
4. Remove the Process Unit. (Refer to page 4-114)
5. Remove the Drum Cleaning Blade. (Refer to page 4-118)
6. Remove the Drum Unit. (Refer to page 4-121)
<Procedure>
1) Remove the Side Seals (Front and Rear).
4
Parts Replacement and Clearning > Image Formation System > Removing the Side Seal
2) Apply Tospearl on the surfaces of the new Drum Side Seals (Front and Rear) and adhere it
uniformly with lint-free paper.
NOTE:
In order to reduce adhesion of toner at both ends of the Photosensitive Drum
Tospearl
3) Align the Drum Side Seals (Front and Rear) with the edges of the sheets and affix them.
Seal
F-4-164
Sheet
Seal
Edge
Edge
4-128
lint-free paper
F-4-165
F-4-166
4-128
Advertisement
Table of Contents
Troubleshooting
