Table of Contents
Advertisement
CZ-RWSU3
Model No.
CZ-RWST3N CZ-RWSL2N CZ-RWSK2
Front side
OPERATION
TIMER
STANDBY
Installation Instructions Separately Attached.
English
Before operating the unit, read these operating instructions thoroughly and keep them for future
reference.
Panasonic Corporation
1006 Kadoma, Kadoma City, Osaka, Japan
CZ-RWSU2N CZ-RWSC3 CZ-RWSD2
1 2 3 4
Rear side
Panasonic Corporation
http://www.panasonic.com
Operating Instructions
Wireless Remote Controller
CV6233317755
Advertisement
Table of Contents
Related Manuals for Panasonic CZ-RWSU3
Summary of Contents for Panasonic CZ-RWSU3
- Page 1 Operating Instructions Wireless Remote Controller CZ-RWSU3 CZ-RWSU2N CZ-RWSC3 CZ-RWSD2 Model No. CZ-RWST3N CZ-RWSL2N CZ-RWSK2 1 2 3 4 Front side Rear side OPERATION TIMER STANDBY Installation Instructions Separately Attached. English Before operating the unit, read these operating instructions thoroughly and keep them for future reference.
-
Page 2: Safety Precautions
Safety Precautions WARNING CAUTION This symbol refers to a hazard This symbol refers to a hazard or unsafe practice which can or unsafe practice which can result in severe personal injury result in personal injury or or death. product or property damage. Matters to be observed Prohibited matters WARNING... - Page 3 Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ...
-
Page 4: Table Of Contents
Contents 1. Important Safety Instructions ..........5 2. Names and Operations ............6 3. Installing Batteries ...............10 4. Setting the Current Time .............11 5. Operation ................12 6. Timer Operation ..............14 7. Adjusting the Wind Direction ..........16 8. Operating Multiple In/Outdoor Units Simultaneously ..17 9. -
Page 5: Important Safety Instructions
1. Important Safety Instructions Before using the system, be sure to Moving and Repair read these “Important Safety Precautions Instructions”. After reading this manual, save it in a • Do not repair. convenient place. Never repair the system yourself. • Contact your distributor before Warning moving the system. -
Page 6: Names And Operations
2. Names and Operations REMOTE CONTROLLER (EN) - Page 7 One remote controller can control a group of up to eight indoor units. (See page 17) 1. Operation Display 11. Filter button Displays the operation status. CZ-RWSC3 (The fi gure shows all the Press to turn off the fi lter lamp on statuses.) the receiver.
- Page 8 2. Names and Operations (Cont.) Receiver CZ-RWSU3 CZ-RWSU2N CZ-RWSD2 CZ-RWSC3 CZ-RWSL2N ADDRESS 1 ADDRESS 2 Display ADDRESS 3 REM SUB/MAIN Operation Panel 1 2 3 4 Front side Rear side CZ-RWST3N CZ-RWSK2 (For wall mounted type indoor unit) OPERATION TIMER...
- Page 9 1. Receiver Note Receives the signal sent from the • If non-cooling/heating free type is being used, it will beep twice and the remote controller. operating lamp will light up on the 2. Emergency operation button display; if the timer and standby lamps blink alternately, a confl...
-
Page 10: Installing Batteries
3. Installing Batteries 1. Remove the cover. 2. Insert two LR03 size batteries. Put the batteries in with the polarity [+/–] as shown in the fi gure. 3. Gently insert one end of an unfolded paper clip (or a similar object that can fi... -
Page 11: Setting The Current Time
4. Setting the Current Time After changing the batteries and pressing the Reset button, be sure to reset the current time. (When the Reset button is pressed, the current time reverts to [ 1. Press for two seconds or more. Once the clock displays starts blinking, the clock can be set. -
Page 12: Operation
5. Operation , Dry , Cool , Fan Auto , Heat Models that only provide the cooling function cannot operate in the auto or heating mode. Power: Turn on the circuit breaker beforehand, referring to the operating instructions for the unit. - Page 13 5. Operation (Cont.) If the unit is not heating very effectively with a Low fan speed , switch the fan speed to High or Medium Depending on the indoor unit being used, it may indicate a function that it does not have. (The fan speed is constant.) If you cannot turn the air conditioner off in the normal way Disconnect the power to the indoor unit and contact the distributor where the product was purchased.
-
Page 14: Timer Operation
6. Timer Operation • When setting the timer, make sure the current time on the remote controller is accurate. • The timer’s clock can only be set when the display of the remote controller is ON. • After setting the timer, put the remote controller for in a place where its signal will reach the receiver of the indoor unit. - Page 15 6. Timer Operation (Cont.) Combining ON and OFF Timers • The ON and OFF timers can be set respectively. Checking the timer setting • If you press either for the or the , the scheduled time is displayed for four seconds. •...
-
Page 16: Adjusting The Wind Direction
Also, bear in mind that the fl ap starts swinging after the heating standby mode is released, but the display on the remote controller indicates Auto Flap during standby heating as well. CZ-RWSU3/CZ-RWSU2N/ In the Heat Mode CZ-RWSD2/CZ-RWSL2N/ Please face the fl... -
Page 17: Operating Multiple In/Outdoor Units Simultaneously
7. Adjusting the Wind Direction (Cont.) CZ-RWSC3 The available functions differ depending on the indoor unit being used. The wind direction cannot be set via remote controller for any models other than those noted below. For more information, please refer to the Operating Instructions that came with your indoor unit. -
Page 18: Using The Remote Controller
9. Using the Remote Controller • Point the transmitter of the remote controller at the receiver. When the signal is received properly, it will beep one time. (It only beeps two times when the unit starts operating.) • The signal can be received at a distance of up to about 6 meters. This distance should be used only as a guide. -
Page 19: Addresses
11. Addresses In both multi and single unit installations, when more than one indoor units are installed in the same room with a compatible wireless remote controller, addresses can be set up to avoid crosstalk. By setting the address switches on the receivers and matching them with the number of addresses on the remote controller, up to six indoor units can be controlled separately with the remote controller. - Page 20 11. Addresses (Cont.) Setting Addresses (CZ-RWSK2) (Setting the address of the indoor unit) 1. Set the address for the remote controller following the procedure under the section “Setting Remote Controller Addresses” (see page 19). 2. Press [Emergency Operation] of the indoor unit for four seconds or longer.
-
Page 21: Emergency Operation
• When the remote controller is broken. • When the remote controller is lost. Figures: CZ-RWSU3, CZ-RWSU2N, CZ-RWSD2, and CZ-RWST3N are of receivers (inside indoor unit), CZ-RWSL2N is of the operation panel (inside indoor unit) and indoor unit (CZ-RWSK2) is of its front panel. -
Page 22: Miscellaneous Settings
13. Miscellaneous Settings A variety of changes can be made to settings, depending on the indoor unit being used. Operation mode indicator, time display (24-hour, AM/PM), heating maximun temperature • (These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are changed, the settings do not have to be made again.) •... -
Page 23: Before Requesting Service
14. Before Requesting Service Before requesting service, please check the following. Problem Cause Solution The unit doesn’t work The power to the indoor unit is not Make sure the power to the indoor even when unit is ON. pressed on the remote Is the Normal/Stop All switch in the Switch it to the Normal position controller. -
Page 24: Specifi Cations
Power source 5 V DC (supplied from the operation panel) Dimensions 55 mm (H) X 120 mm (W) X 16 mm (D) Operation 16 V DC (Supplied from the terminal strip of the indoor unit’s remote Panel Power source controller) © Panasonic Corporation 2016 (EN)