Ip Igmp Snooping Port-Purge-Interval - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

The parameter has the following meaning:

switch-ipaddr

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The IP address is configured.

ip igmp snooping port-purge-interval

The time after which a port is deleted from the list if no IGMP router control packets are

received is known as the purge time.

With this command, you configure this purge time for a port for a VLAN in seconds.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call up the command with the following parameters:

ip igmp snooping port-purge-interval <(130-1225)seconds>

The parameters have the following meaning:

The purge time is configured.

Further notes

You can reset the setting to the default with the

You can display the status of this function and other information with the

snooping globals

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Address of the source

Value for the purge time in seconds

Layer 2 management protocols

Range of values / note

Specify a valid IP address.

Default: 0.0.0.0

Range of values / note

130 ... 1225

Default: 260

no ip igmp snooping port-purge-interval

8.3 IGMP snooping

show ip igmp