Table of Contents
Advertisement
SmartPAC 2 with WPC Integration
Part 1 – Using SmartPAC 2 in Run Mode
How to Enter and Exit Run Mode
NOTICE
• Load a tool number before entering Run mode. See next section.
• Find instructions for running the press at the end of this chapter, starting on page 364.
To Enter Run Mode
Turn the Program/Run key toward RUN.*
*
If you turn the key and nothing happens, press RESET repeatedly until the SmartPAC 2 changes modes. To
prevent this problem, before you turn the Program/Run key, make sure SmartPAC 2 is in the main (or top) menu for
the mode it is in. If it is not, press RESET repeatedly until the main menu appears.
NOTICE
SELECT = HIGHLIGHT + ENTER
When this manual says "select," it means highlight the item and press ENTER.
For HELP press the HELP key located at the center of the cursor (arrow) keys.
Load A Tool Number Before Switching to Run Mode
A tool number must be loaded before SmartPAC 2 will allow the press to run. If no tool
number is loaded, you cannot switch from Initialization mode or Program mode to Run
mode.
If you switch to Run mode without a tool number loaded, you will get this error message on
your screen:
SmartPAC 2 Run Mode
Figure 6 - 3. No Tool Loaded Warning
Chapter 6
To Exit Run Mode
To go to Program mode:
Turn the Program/Run key toward PROG.*
1126800
page 325
- Quick Links:
- Smartpac 2
Hide quick links:
Advertisement
Table of Contents
