Do not touch the leaked liquid from the batteries.
If you touch the leaked liquid, it may hurt your skin.
Immediately wash away the liquid with water and
seek medical advice.
If you get the leaked liquid in your eye, it may cause
blindness or damage. Never rub your eye, and
immediately wash away the liquid with water and
seek medical advice.
During a thunderstorm, do not touch the projector or
the cable.
Electric shocks can result.
Do not use the projector in a bath or shower.
Fire or electric shocks can result.
Do not place your skin into the light beam while the
projector is being used.
Strong light is emitted from the projector's lens. If you
place directly into this light, it can hurt or damage
your skin.
Do not look into the lens while the projector is being
used.
Strong light is emitted from the projector's lens. If you
look directly into this light, it can hurt and damage
your eyes.
Do not disassemble the lamp unit.
If the lamp section breaks, it may cause injury.
Do not place your hands or other objects close to the
air outlet port.
Heated air comes out of the air outlet port. Do not
place your hands or face, or objects which cannot
withstand heat close to this port [allow at least
50 cm (20") of space], otherwise burns or damage
could result.
Replacement of the lamp should be carried out by a
qualified technician.
The lamp has high internal pressure. If improperly
handled, explosion might result.
The lamp can easily become damaged if struck
against hard objects or dropped, and injury or
malfunctions may result.
CAUTIONS
Do not cover the air inlet port or the air outlet port.
Doing so may cause the projector to overheat, which
can cause fire or damage to the projector.
Do not place the projector in narrow, badly ventilated
places such as closets or bookshelves.
Do not place the projector on cloth or papers, as
these materials could be drawn into the air inlet port.
Precautions with regard to safety
When replacing the lamp, allow it to cool for at least
one hour before handling it.
The lamp cover gets very hot, and touching it can
cause burns.
Before replacing the lamp, be sure to disconnect the
power plug from the wall outlet.
Electric shocks or explosions can result if this is not
done.
Do not allow infants or pets to touch the remote
control unit.
Keep the remote control unit out of the reach of
infants and pets after using it.
After removing the battery from remote control unit,
keep it away from the reach of children.
The battery can cause death by suffocation if
swallowed.
If the battery is swallowed, seek medical advice
immediately.
Insulate the battery using tape or similar before
disposal.
If the battery comes into contact with metallic objects
or other batteries, it may catch fire or explode.
When installing to a ceiling, be sure to use the
accessory wire (install in a different location to the
ceiling mount bracket) and the eye bolts as an extra
preventative measure to stop the projector from
falling down.
If the projector is not secure enough, accidents may
result.
Do not place sets directly on top of each other.
If this is not observed, accidents may result.
Do not use the projector while the projection lens
cover is still attached to the projection lens.
If this is not observed, fire may occur.
Do not set up the projector in humid or dusty places
or in places where the projector may come into
contact with oily smoke or steam.
Using the projector under such conditions may result
in fire, electric shocks or plastic deterioration. The
plastic deterioration may cause the falling down of
the projector which is mounted on the ceiling.
E
NGLISH - 7