Advertisement
Quick Links
S-STP500
1 2What's in the box
Check that you have all the supplied accessories before you start:
• Front speakers x 2
• Center speaker x 1
• Surround speakers x 2
• Speaker cords x 1
• Non-skid pads
• Brackets for wall mounting x 4
• Screws x 4
• These operating instructions
Before you start
Thank you for buying this Pioneer product.
Please read through these operating instructions before installing
and using your speaker system.
Important
In order to prevent damage to the speaker system resulting from
input overload, please observe the following precautions:
• Do not supply signal to the speaker system in excess of the
maximum permissible input.
• When connecting or disconnecting cables, make sure that your
amplifier is switched off.
• Do not use excessive amplifier volume if using a tone control to
emphasize high or low frequencies.
Caution
• Do not connect the supplied speakers to any amplifier other
than the one supplied with this system. Connection to any other
smplifier may result in malfunction or fire.
• Pioneer will not be responsible for any accidents or damage that
may result from improper installation.
OPERATING INSTRUCTIONS
Making receiver settings
Before connecting the speakers, please read the Operating
Instructions supplied with your VSX-416 receiver to make the
following settings:
• Switch the speaker impedance to the 6 Ω setting (see Switching
the speaker impedance to do this).
• Set the crossover frequency to 200 Hz (see Crossover network to
do this).
After connecting the speakers, please complete Using the Quick
Setup with the 5.1ch setting (refer to the receiver's 5 minute guide in
the supplied Operating Instructions).
Connecting the speakers
To get the best out of your speakers it is important that you connect
them properly to your amplifier or receiver. Each speaker
connection consists of a positive (+) and a negative (–) terminal.
These should be matched between the amplifier and the speaker.
Important
• Make sure all equipment is turned off before making any
connections.
1
Twist and pull off the protective shields on each speaker
wire.
2
Attach one end of the supplied speaker cord to the rear of
the center speaker.
Connect the wire with the colored marker to the red (+) terminal; the
plain wire to the black (–) terminal. Press down the spring-loaded
tab and insert the wire, as shown below. Release the tab to secure
the wire.
Red (+)
Black (–)
www.pioneerelectronics.com
SPEAKER SYSTEM
Green colored
marker
Advertisement
Related Manuals for Pioneer S-STP500
Summary of Contents for Pioneer S-STP500
-
Page 1: Operating Instructions
• Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other smplifier may result in malfunction or fire. • Pioneer will not be responsible for any accidents or damage that may result from improper installation. -
Page 2: Placing The Speakers
Connect the other end of each speaker cord to your receiver. Placing the speakers To connect, insert the colored wire into the matching positive • The diagram below shows the standard speaker placement (colored) terminal and the other wire into the negative (black) relative to your listening position. -
Page 3: Troubleshooting
• If you are unsure of the qualities and strength of the walls, without notice due to improvements. consult a professional for advice. • Pioneer is not responsible for any accidents or damage that result from improper installation. Bracket screw... - Page 4 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: (03) 9586-6300 PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico,D.F. 11000 TEL: 55-9178-4270 K002_A_En <06D000001>...