Poor Drying Results; No Drying Or Drying Too Slow - Miele G1000 Technical Information
Miele dishwashers technical information
Hide thumbs
Also See for G1000:
- Option installation manual (2 pages) ,
- Installation instructions (1 page) ,
- Installation diagram (1 page)
Table of Contents
Advertisement
Technical Information
Note
For remedies to clear blockage see Fault code F11 "Drainage fault",
6.8.13.
6.8.11
Poor Drying Results
1. Incorrect Dispenser setting.
a. Adjust setting as necessary.
2. Rinse Aid Dispenser Flap not properly closed. The Rinse Aid Container filed
with water during program operation.
a. Flush the Dispenser, refill with new Rinse Aid.
b. Replace Dispenser Assembly as necessary (5.2.6).
3. Rinse Aid not being dispensed/released.
a. Ensure Dispenser is operating. Replace Combination Dispenser
as necessary.
4. Combination products are being used, and the function "2in1" or "3in1" is
selected. After a time, the drying results become poor. All rinse aid remnants
were flushed from the dispensing unit (for background information refer to the
section "intelligent tab function"). Thus only the rinse aid components of the
combination product are available for the drying cycle.
a. Check the fill level of the rinse aid in the dispensing unit.
b. Refill with standard rinse aid.
6.8.12
No Drying Or Drying Too Slow
1. Fan run-on time too short. (If applicable)
a. Extend the Fan run on time. See applicable programming mode.
2. Fan not functioning
a. Check circuit, perform service as necessary.
3. No Heat, Fault Code F01, F02, F25, or F52. After this fault is registered, the
heating will not be activated, no rinse aid is dispensed. May also note that dishes
are still dirty.
a. NTC temperature sensor R30 or its connection leads short-
b. Check the plug connections
c. Check the temperature sensor and its leads for continuity. At 68°F (20°C) the
d. Replace the NTC Temperature sensor if necessary (5.4.19).
4. Water/Heating NTC temperature sensor or leads open-circuited (F02).
a. Check plug connections
b.
c. Replace the NTC temperature sensor if necessary (5.4.19).
circuited (F01).
temperature sensor resistance should be approx. 14.9Ω (±600Ω) and at 77°F
(25°C) approx. 12Ω (±600Ω) (guide figures only).
Check the temperature sensor and its leads for continuity.
G1000 / G2000 Dishwashers
208
Hide quick links:
Advertisement
Table of Contents
