Bosch ASCENTA Care Manual page 19
Dishwasher
Hide thumbs
Also See for ASCENTA:
- Use & care manual (64 pages) ,
- User manual (80 pages) ,
- Instructions for use manual (40 pages)
Table of Contents
Advertisement
Available languages
Available languages
Operating the Dishwasher
SHE5AL, SHE4AP
To start the dishwasher:
Door must be closed. Press the "ON/OFF" button.
One of the Wash Cycle LEDs will be lashing. You can
now select a wash cycle.
Press the "<" or ">" button to select the desired wash
cycle.
Select the "Half Load" or "Delay Start" features if
desired at this point.
If you would like to delay the start time of the dishwasher
press the "DELAY" button until the desired delay time
(3,6,9 hrs.) is displayed by the corresponding LED.
Press the "START" button to begin the cycle (Wash
Cycle Indicator Light will stop lashing)
NOTE: Rinse Agent Indicator Light will be illuminated if
the unit needs Rinse Agent.
Child Lock
After pressing the "START" button you can activate
the Child Lock feature.
Press and hold down the "<" button until Child Lock
LED illuminates (Light goes out when button is
released).
Now any button you press (except ON/OFF) will not
function and the Child Lock LED illuminates when
you press any button.
To deactivate, press and hold the "<" button until the
Child Lock LED goes out.
To cancel a cycle:
Press and hold the "START/RESET" button until the
"Active" LED goes out.
Wait for about 1 minute until the dishwasher drains.
The "Clean" indicator light will illuminate when done
draining.
Turn unit o by pressing the "ON/OFF" button.
You are now ready to start a new cycle.
To enter the options mode(rinse agent setting, ex-
tra dry heat, cycle completion signal):
Door must be closed. Press the "ON/OFF" button to
turn the unit on.
One of the Wash Cycle LEDs will be lashing.
Press and hold down the ">" button, then press and
release the "START/RESET" button. Now release the
">" button.
The "Clean" and one other LED will be lashing. You
are now in the options setup mode.
Press ">" to select the option you would like to
adjust.
If the "Clean" and "Rinse Agent" LED are lashing you can
adjust the Rinse Agent settings.
If the "Clean" and "Sanitized" LED are lashing you can set
the Extra Dry Heat.
To set the amount of Rinse Agent:
NOTE: If your glasses have spots on them, you need more
rinse agent. If your glasses have streaks, you need less
Rinse Agent.
Follow the prior instructions to enter "options" mode.
With the
"Clean" and "Rinse Agent" LED
Press the "<" button to change the amount of rinse
agent dispensed.
0 LEDs lashing --> Rinse Agent dispenser is OFF
1 LED lashing --> Lowest amount of rinse agent
2 LEDs lashing --> Medium amount dispensed
3 LEDs lashing --> Highest amount of rinse agent
Press START to save your settings.
To turn Extra Dry Heat on or of:
With the
"Clean" and "Sanitized" LED
Press the "<" button to turn Extra Dry Heat on or o . 0
0 LEDs lashing --> Extra Dry Heat is OFF
1 LED lashing --> Extra Dry Heat is ON
Press START to save your settings.
lashing:
lashing:
19
Hide quick links:
Advertisement
Chapters
Table of Contents
