hit counter script

Epson EB-G5950 User Manual page 65

Epson multimedia projector user's guide
Hide thumbs Also See for EB-G5950:
Table of Contents

Advertisement

Network Menu (EB-G5900/G5800/G5600/G5500)
Sub Menu
SNMP
Mail
AMX Device Discovery
Projector Name
Reset
*
When inputting numbers and passwords, the following software keyboards are displayed. Use the [h] button on the remote control to move the cursor to the desired key,
and then press the [Enter] button to enter the character. Enter figures by holding down the [Num] button on the remote control, and pressing the numeric buttons. After
inputting, press [Finish] on the keyboard to confirm your input. Press [Cancel] on the keyboard to cancel your input.
Set this parameter to On when using SNMP
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a
network expert. s
p.115
Trap IP Address 1 or Trap IP Address 2: When SNMP is set to On, you can register up to two IP addresses as SNMP trap notification
*
destinations.
When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. For information on the contents of the
sent email, s "Reading Problem Mail Notification Function"
Mail Notification: You can set whether or not (On/Off) to be notified by e-mail. If this is set to Off you cannot set any more
addresses.
SMTP Server: You can input the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Port Number: You can display the SMTP server's port number.
The default value is 25. When editing settings from Web Control, you can change Port Number by entering a valid number from 1 to
65535.
Address 1 Setting/Address 2 Setting/Address 3 Setting: You can enter the e-mail address
notification when a problem or warning occurs. You can register up to three destinations. You can enter up to 64 single-byte alphanumeric
characters for the e-mail addresses.
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery
Off if the projector is not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
Displays the projector name used to identify the projector when connected to a network.
You can reset all adjustment values for the Network menu to their default settings.
To return all menu items to their default settings, see s
Function
g
to monitor the projector.
p.114
p.83
*
*
and the contents of the message to receive
65
g
. Set this to

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eb-g5900Eb-g5800Eb-g5650wEb-g5600Eb-g5500

Table of Contents