hit counter script

Epson EMP-835 User Manual page 109

Projector
Hide thumbs Also See for EMP-835:
Table of Contents

Advertisement

Problem Solving
The projector cannot be monitored and controlled using the EMP Monitor function
Check
Is the network cable connected correctly?
When using the EMP-835
connected to a wired LAN, or
when using the EMP-830
Is the wireless LAN card inserted?
When using the EMP-835
connected to a wireless LAN
Are the settings for connecting to a network
correct ?
Has EMP Monitor function been correctly
installed to the computer?
Have all projectors that are to be monitored
and controlled been registered in the
projector list?
Has "Standby Mode" been set to "Network
ON"?
Is power being supplied to the projector?
Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
Check that the wireless LAN card is correctly inserted into the card slot of the projector.
s"Inserting and Removing Cards"
Check the network settings for the projector.
If using the EMP-835 s"Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP
Network Setup Guide
sp.90
If using the EMP-830
Uninstall EMP Monitor and then re-install it.
If using the EMP-835 s"If You would like to Uninstall the EasyMP Software" and "Installing
EasyMP Software" in the EasyMP Network Setup Guide
s"Installation and
If using the EMP-830
Guide
Register the projector in the projector list.
If using the EMP Monitor function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON". s"Extended" - "Standby Mode"
Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Remedy
p.16
Uninstallation" in the EMP NetworkManager Operation
sEMP Monitor Operation Guide
User's Guide
108
p.85

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emp-830

Table of Contents