Table of Contents
Advertisement
11
Inside of cart, connect the five wires from burner electrodes into the back of Electronic Ignition module,
positions 1 - 5, shown A.
Connect the two wires [(a) and (b)] from switch wiring harness into the back of Electronic Ignition module,
shown A.
Note: Switch terminals are larger than electrode terminals and should only be installed in locations (a)
and (b).
Remove the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left
side panel with the nut, shown B.
Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.
A
Tie wrap
Electronic ignition
module
12
Attach towel bar to right side extended shelf using two 1/4-20x1/2" screws, 7mm lock washers and 7mm
flat washers.
1/4-20x1/2" screw
Qty.2
7mm lock washer
Qty.2
7mm flat washer
Qty.2
(a)
1
4
2
5
(b)
3
1/4-20x1/2" screw
B
Nut
Left side panel
NOTE: Wires omitted for clarity of illustration.
C
AA battery
Right side fascia
screw
7mm flat
7mm lock
washer
washer
Extended shelf
Electronic ignition
module
-
Cap
+
Towel bar
464224411 • 23
- Quick Links:
- Parts List
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
