Completing The Parts Replacement - Lenovo ThinkCentre 3025 User Manual

Thinkcentre

Hide thumbs Also See for ThinkCentre 3025:

Table of Contents

Completing the parts replacement

After completing the installation or replacement for all parts, you need to close the

computer cover and reconnect cables. Depending on the parts you installed or

replaced, you might need to confirm the updated information in the Setup Utility

program. Refer to Chapter 4, "Using the Setup Utility," on page 41.

To close the computer cover and reconnect cables to your computer, do the

following:

1. Make sure that all components have been reassembled correctly and that no

tools or loose screws are left inside your computer. See "Locating components"

on page 10 for the locations of various components in your computer.

2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling

the front bezel" on page 15.

3. Make sure that the cables are routed correctly. Keep cables clear of the hinges

and sides of the computer chassis to avoid interference with closing the

computer cover.

Figure 21. Cable routing

4. Close the computer cover as shown.

5. If there is an integrated cable lock available, lock the computer.

6. Reconnect the external cables and power cords to the computer. See "Locating

connectors on the rear of your computer" on page 8.

7. To update your configuration, see Chapter 4, "Using the Setup Utility," on page

41.

Note: In most areas of the world, Lenovo requires the return of the defective

Customer Replaceable Unit (CRU). Information about this will come with

the CRU or will come a few days after the CRU arrives.

Obtaining device drivers

You can obtain device drivers for operating systems that are not preinstalled at

http://www.lenovo.com/support. Installation instructions are provided in readme

files with the device-driver files.

Chapter 2. Installing or replacing hardware

Table of Contents