Related Manuals for Miele K 8452 S
Summary of Contents for Miele K 8452 S
- Page 1 Operating and installation instructions Refrigerator K 8452 S To avoid the risk of accidents or damage to the appliance, it is to read these operating instructions before it is installed or used for the first time. M.-Nr. 06 203 430...
- Page 2 ......... 4 .
- Page 3 ............27 Location .
- Page 4 a Temperature display c On/Off and temperature selector dial b Super cool button and indicator light a Interior lighting e Fruit and vegetable containers b Shelves f Butter and cheese compartment c Bottle rack (depending on model) g Egg tray d Condensate channel and drain hole h Door shelf i Divider...
- Page 5 Old appliances contain materials which can be reclaimed or recycled. Please The transport and protective packing contact your dealer, your local waste has been selected from materials which collection centre or scrap merchant are environmentally friendly for disposal about potential recycling schemes. and can normally be recycled.
- Page 6 This appliance complies with all This appliance contains the coolant relevant legal safety requirements. Isobutane (R600a), a natural gas Improper use can, however, present which is environmentally friendly. a risk of both personal injury and Although it is flammable, it does not material damage.
- Page 7 Before connecting the appliance to persons could be dangerous and the the mains supply make sure that manufacturer will not be held liable. the rating on the data plate Ensure current is not supplied to the corresponds to the voltage and appliance while maintenance or repair frequency of the household supply.
-
Page 8: In The Refrigerator
Observe the "use by" dates given The appliance is designed for use on food to avoid the risk of food within certain climate ranges poisoning. (ambient temperatures), and should not Storage times will depend on several be used outside this range. The climate factors, including the freshness and range for your appliance is stated on quality of the food as well as the... - Page 9 Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. Disconnect it from the mains. Cut off the cable and render any plug unusable.
- Page 10 In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven). (radiator, oven). Where the ambient room Where there is a high ambient room temperature is ideal at approx.
-
Page 11: Temperature Display
^ Clean the inside of the appliance and the accessories with warm water and If the appliance is not going to be used a little washing up liquid, and then for a longer period of time, e.g. whilst dry with a soft cloth. on holiday, ^ switch the appliance off, Important:... - Page 12 It is very important to set the correct Please note the following: temperature for storing food in the – bathwater and other household appliance. Micro-organisms will cause thermometers are not very accurate. food which is not stored at the correct It is best to use an electronic temperature to deteriorate rapidly.
- Page 13 The temperature display on the control panel always shows the temperature. If you want the temperature in the refrigerator to be 5 °C, ^ turn the temperature dial clockwise from 0 until 5 lights up on the control panel.
- Page 14 The Super cool function can be used to The super cool function switches itself rapidly reduce the temperature in the off automatically after approx. 6 hours. refrigerator to its lowest setting The indicator light goes out and the (depending on the room temperature). appliance continues running at normal power.
-
Page 15: Fruit And Vegetables
Do not store explosive materials in Due to the natural circulation of the air the appliance or any products in the appliance, there are different containing propellants (e.g. spray temperature zones in the refrigerator. cans). Danger of explosion. Cold, heavy air sinks to the lowest section of the appliance. - Page 16 Store food covered or packaged. This will prevent food smells or tastes from affecting other foods, and prevent food from drying out and also any cross-contamination of bacteria. The growth of bacteria, such as salmonella, can be avoided by setting the correct temperature and maintaining good standards of hygiene.
- Page 17 ^ Push the door shelf upwards, then The shelves can be adjusted according to the height of the food. remove it by pulling it forwards. ^ Raise the shelf at the front, pull it out ^ Replace the door shelf at the half way, and then lift it out.
- Page 18 Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. These are automatically removed and defrosted by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance.
- Page 19 ^ A microfibre "E-Cloth" is available The data plate located inside the from the Miele UK Spare Parts appliance must not be removed. It Department which is suitable for contains information which is required cleaning surfaces such as stainless in the event of a service call.
- Page 20 Warning: The handle is susceptible to scratches and abrasions. In addition to the cleaning agents The metal grille at the back of the mentioned previously, you should also appliance (heat exchanger) should be avoid dusted at least once a year. A build-up of dust will increase the energy –...
- Page 21 ^ Check that the fuse is not defective withdraw the plug from the socket, or and that the mains fuse has not disconnect the mains fuse or remove blown. If it has, contact the Miele Ser- the screw-out fuse in countries where vice Department. this is applicable.
- Page 22 ^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these suggestions, please contact the Miele Service Department. To prevent unnecessary loss of temperature it is advisable not to open the door while waiting for the...
- Page 23 Humming noise made by the motor (compressor). This noise can get louder for brief periods when the motor is switching on. A gurgling noise can be heard when coolant is circulating through the pipes. Clicking sounds are made when the thermostat switches the motor on and off.
- Page 24 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
- Page 25 The appliance is supplied with a mains The wires in the mains lead are cable and moulded plug ready for coloured in accordance with the connection to an a.c. single phase following code: 220 – 240 V 50 Hz supply. The fuse Green/yellow = earth rating is 13 amps.
- Page 26 If this machine is fitted with a non-rewireable plug, the following information applies: If the socket outlets are not suitable for the plug supplied with this product, it must be cut off and an appropriate plug fitted. The fuse carrier and the fuse should be removed from the old plug and disposed of.
- Page 27 temperature in the appliance to rise Do not place any appliance which with the risk of food deteriorating and gives off heat, such as a toaster or going off. microwave oven, on top of this appliance, as this would increase the appliance's energy Air at the back of the appliance gets consumption.
-
Page 28: Door Handle
^ Remove the cover caps from the The appliance is supplied right-hand hinged. If left-hand door hinging is opposite side, and fit them into the required, follow the instructions below. empty holes. ^ Open the appliance door. First the side section of the handle must be removed: ^ Pull door handle a towards you. - Page 29 In the following illustration the door is not shown in the closed position to make it easier to see what happens next. ^ Open the door, tilt it downwards and take it off. Take care not to lose washer a. ^ Using a screwdriver remove covers ^ Turn door support b around, pull hinge pin a out, and refit on the...
- Page 30 ^ With the door open, position cover e in the front of the plinth fascia, and push it firmly into position. ^ Loosely screw the handle to the opposite side of the door. The mounting plate must fit snugly to the door housing.
-
Page 31: Ventilation Gaps
The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. When built into a kitchen run (max. depth 580 mm) the appliance can be installed directly next to a kitchen furniture housing unit. - Page 32 Alteration rights reserved / 1104 M.-Nr. 06 203 430 / 00 en / GB K 8452 S This paper consists of cellulose which has been bleached without the use of chlorine.