Table of Contents
Advertisement
Using Remote control
Installing and Removing batteries
1 )
Open the cover
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 65 different ID codes (All, Code 1~Code 64), the initial ID number is [All].
Setting the ID number
J
While holding down the <MENU> button, enter a 1-digit or 2-digit number
1)
corresponding to the desired ID code number by using the number buttons 0 to 9.
The ID code is changed when the <MENU> button is released.
2)
The examples are as follows
3)
Code 1= <MENU>+<1> or <MENU>+ <0> + <1> ,
Code 2= <MENU>+<2> or <MENU>+ <0> + <2>,
Code 16= <MENU>+ <1> + <6>, Code 64= <MENU>+ <6> + <4>
Resetting the ID number
J
The ID code is reset to [All] (default) by pressing the <MENU> button and <0> button
1)
at the same time for 5 seconds or more.
Attention
The remote control transmission is disabled during
z
the ID code change procedure.
The status of the ID code is not stored after replacing batteries
z
Note
For details, please refer to the [Remote control] of the
z
[Setting] menu. (
Æ
24
- ENGLISH
:
page 67)
2 )
Install batteries and close the cover
(Insert the – side first.)
Remove the batteries in the reverse order of
z
installation.
.
MENU button
Number buttons
- Quick Links:
- Lamp Unit
Hide quick links:
Advertisement
Table of Contents
