Laundry Guide; Cleaning The Machine; Trouble Shooting - Samsung WT10S2 Owner's Instructions
Hide thumbs
Also See for WT10S2:
- Owner's instructions manual (8 pages) ,
- Manual de instrucciones (10 pages)
Table of Contents
Advertisement
INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2 )
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about
70~80cm above the ground
for pump model.
CLEANING THE MACHINE
1. OVERFLOW FILTER
Pull the upper side of the
overflow filter with
your fingers into the holes
in the direction of arrow as
shown in the figure.
3. CLEANING THE WASHER BODY
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene,thinners,cleanser,or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
CHANGING THE POSITION OF THE DRAIN HOSE
Before attempting to change the position of the drain hose,
disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and
insert the drain hose into the hose holder.
2
1
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it
locks in position.
Open
2. CLEANING THE FILTER
Pull the overflow filter out and take up the filter
by removing 3 screws as shown in figure.
Wash the filter and washing tub.
7
AMOUNT OF CLOTHES
Water Level
Shirts(Synthetics)
Under Shirts(Cotton)
Working clothes(Cotton)
DETERGENT
AMOUNT OF
DETERGENT
44g
Hose holder
56g
67g
-The amount of detergent is average.
Follow the instruction detergent printed on the package for
amount of detergent.
-Choose the amount of detergent depending on the fabric type.
Filter
WHEN YOU LOAD THE LAUNDRY INTO
Close
THE SPIN BASKET.
Press the laundry evenly and put the safety
Rag
cover into the spin basket drum as shown in
the figure.
TROUBLE
The washer
does not work.
Clothes will
not move freely.
Incomplete
spinning
LAUNDRY GUIDE
Low
Middle
22 Pieces
29 Pieces
38 Pieces
48 Pieces
16 Pieces
20 Pieces
WATER
LEVEL
Low(44 )
Middle(56 )
High(67 )
TO PICK OUT THE CLOTHING WHICH HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safty, pull the power supply plug out of the socket.
1.Disassemble two screws from the spin dryer hatch.
2.Pull up the spin dryer hatch to remove it.
3.Remove the clothing.
4.Close the spin dryer hatch.
TROUBLE SHOOTING
CHECK POINT
TROUBLE
Check that the power cord is
Incomplete
connected to a power outlet well.
draining
Power stoppage?
Is the laundry overloaded?
The spin dryer
basket will not
run.
Are the laundry arranged evenly?
8
High
35 Pieces
58 Pieces
25 Pieces
SPIN DRY TIME
TIME
TYPE OF LAUNDRY
1min.
Thin(synthetic fiber)
1~2min.
wool
cotton
3~5min.
5min.
thick(cotton)
MAINTENANCE
CHECK POINT
filter clogged
Is the
with lint?
See "Cleaning the
machine" on page 7.
Is the spin dryer lid closed
completely?
Are laundry(socks,etc.)falling
out of the spin dryer basket and
clinging to the axle?
See To pick out... on page 8.
- Quick Links:
- Description of Parts
Hide quick links:
Advertisement
Table of Contents
