Installing Flat Panel Screen To Wall Plate - NEC E321 Installation And Assembly Manual
Flat screen wall mount
Hide thumbs
Also See for E321:
- Installation manual (8 pages) ,
- Specifications (2 pages) ,
- User manual (70 pages)
Table of Contents
Advertisement
Mounting and Removing Flat Panel Screen
WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
3
Tension Adjustment of Ratchet Handle:
tension in tilt brackets (B & C) by rotating ratchet
handle. NOTE: If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up or
down position or interference will occur while hooking tilt
brackets to wall plate (A). Slowly hook tilt brackets (B
& C) onto wall plate (A) and swing screen down as
shown in fig. 3.1. Tilt bracket hooks must fully engage
wall plate. Using phillips screw driver or security allen
wrench (F), turn safety/security screws on tilt brackets
(B & C) clockwise till screw tip securely contacts wall
plate as shown in cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety/security screws on tilt
brackets (B & C) three full turns. Adjust screen as
shown in figure 3.2. Tighten safety/security screws on
tilt brackets till screw tip securely contacts wall plate
as shown in cross section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
Adjusting the Tilt Angle of the Flat
Panel Screen
4
For preset tilt angles use
angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to find tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to step
3 for tension adjustment of handle).
top or bottom of screen to adjust tilt as shown in figure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
Visit the Peerless Web Site at www.peerlessmounts.com
Adjust
Increlok™ and for custom tilt
10°
or 15°. Use
Push or pull from
A
SAFETY/
SECURITY
SCREW
CROSS SECTION
fig 3.2
IncreLok™
TILT LOCKING
SCREW
DETAIL 2
RATCHET
HANDLE
7 of 7
ISSUED: 03-26-10 SHEET #: 125-9106-3 08-04-10
For customer care call 1-800-729-0307 or 708-865-8870.
All other brand and product names are trademarks or registered trademarks of their respective owners.
RATCHET
HANDLE
B
&
C
LOCATOR
HOLE
fig 4.1
© 2009, Peerless Industries, Inc. All rights reserved.
fig 3.1
Advertisement
Table of Contents
