Note On Startup Screen (Menu Language Select Screen) - NEC VT70 User Manual
Hide thumbs
Also See for VT70:
- Installation manual (6 pages) ,
- Control commands (54 pages) ,
- Command manual (56 pages)
Table of Contents
Advertisement
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 8 menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
languages for the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu opera-
tion.
If you want, you can select the menu language later. See "Lan-
guage" on pages
35
and 41.
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
When the Lamp mode is set to Eco, the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal
components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and
then turn on the power.
or
button to select one of the 8
3. Projecting an Image (Basic Operation)
SELECT
SELECT
22
LAMP
STATUS
POWER
VIDEO
S-VIDEO
COMPUTER-1 COMPUTER-2
ON/STAND BY
AUTO
ADJ.
OFF
ON
POWER
MAGNIFY
PIC-MUTE
PAGE
UP
DOWN
MENU
ENTER
EXIT
LAMP
STATUS
POWER
VIDEO
S-VIDEO
COMPUTER-1 COMPUTER-2
ON/STAND BY
AUTO
ADJ.
OFF
ON
POWER
MAGNIFY
PIC-MUTE
PAGE
UP
DOWN
MENU
ENTER
EXIT
- Quick Links:
- Setting up the Screen and the...
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
