Programming The I605 Unit; Connecting The Unit To The Rss Workstation - Motorola iDEN i605 Field Service Manual
Digital multi-service, data-capable portable
Hide thumbs
Also See for iDEN i605:
- User manual (173 pages) ,
- User manual (210 pages) ,
- Manual (161 pages)
Table of Contents
Advertisement
BASIC LEVEL TEST MODES AND PROCEDURES: Programming the i605 Unit
Programming the i605 Unit
Use Radio Service Software (RSS) to program a new software version or to program codeplug user
information. Refer to the Radio Service Software User's Guide for information on the setup and use
of RSS.
Connecting the Unit to the RSS Workstation
Some technician tests enter programming information into the unit. To perform these tests, the unit
must be correctly connected to the test equipment.
Equipment Required: Data cable RS232 or USB data cable, computer workstation with RSS
NOTE: For a list of recommended programming equipment, applicable part numbers, and
descriptions, refer to Appendix A: Ordering Replacement Parts and Kits.
To prepare the unit for both codeplug and subscriber code programming using the
data cable (Figure 6-1):
1. Open the Accessory Connector Seal(if so equipped) and attach the 17-pin connector on the data
cable to the corresponding Accessory Connector located at the base of the unit.
2. Attach the other end of the data cable to the serial port or USB port on the RSS computer
workstation that is used for testing purposes.
Refer to the Radio Service Software User's Guide for more information on setting up your test
computer as an RSS workstation.
6-8
installed
Unit Under Test
Data Cable RS232
RS232
(NKN6544) or
or
USB Data Cable
USB Data Cable
(NNTN4007)
Figure 4-1. Data Cable Programming Setup
Computer
Workstation
(RSS)
Serial Port/
USB Port
68P80400P86-O
Advertisement
Table of Contents
Troubleshooting
