Table of Contents
Advertisement
Fault
The spin cycle runs
several times.
The programme dura-
tion changes during
the wash cycle.
No water is visible in
the drum.
Drum jerks after the
programme starts.
Residual water is
present in the com-
partment
.
Vibrations and move-
ment of the appliance
whilst spinning.
Drum rotates, water
does not flow in.
Cause and troubleshooting
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
Water is below the visible area.
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
▶
is operating.
This is caused by an internal motor test.
Not a fault – no action required.
▶
Insert in compartment
→ "Cleaning the detergent drawer", Page 34
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Load detection is active.
Not a fault – no action required.
▶
Note: The load detection can take up to two minutes.
Troubleshooting en
is blocked.
43
Advertisement
Table of Contents
