Replacing Belt; Shave Plate And Skid Shoes - Craftsman SNOW THROWER 247.88853 Owner's Manual
9 horse power 28" two-stage wheel drive snow thrower
Hide thumbs
Also See for SNOW THROWER 247.88853:
- Owner's manual (64 pages) ,
- Owner's manual (64 pages)
Table of Contents
Advertisement
Available languages
Available languages
Carburetor
WARNING:
If any adjustments are made to
the engine while the engine is running (e.g.
carburetor), keep clear of all moving parts. Be
careful of heated surfaces and mufflers.
Minor carburetor
adjustments
may be required to
compensate
for differences
in fuel temperature,
altitude
and load.
Service
Augers
The augers are secured to the spiral shaft with two
shear bolts and hex lock nuts. See Figure 27. If you hit
a foreign object or ice jam, the snow thrower is
designed
so that the bolts will shear. This type of nut is
used where vibration occurs.
•
If the augers do not turn, check to see if the bolts
have sheared. Two replacement
shear bolts and
hex lock nuts have been provided with the snow
thrower. Since lock nuts cannot be threaded
onto a
bolt by hand, use a wrench. When replacing bolts,
spray an oil lubricant into shaft before inserting new
bolts.
•
To remove shave plate, remove carriage bolts,
belleville washers and hex nuts which attach shave
plate to the snow thrower housing. For location of
shave plate, see Figure 27.
•
Reassemble
new shave plate, making sure heads
of the carriage bolts are to the inside of the housing.
Tighten securely.
Replacing Belt
,_
WARNING:
Disconnect the spark plug wire
from the spark plug and ground.
Auger Belts
•
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping
screws.
See Figure 28.
Self-Tapping Screw
Hex Nut
Carriage
Bolt
Shave
Plate
Figure 27
Shave Plate and Skid Shoes
•
The shave plate and skid shoes on the bottom of
the snow thrower are subject to wear. They should
be checked periodically
and replaced when
necessary.
•
Remove the four carriage bolts, belleville washers
and hex nuts which attach skid shoes tothe snow
thrower on two sides. See Figure 27.
•
Reassemble
new skid shoes with the four carriage
bolts, belleville washers
(cupped side goes against
skid shoes) and hex nuts. Make certain the skid
shoes are adjusted to be level.
Self-Tapping Screw
Figure 28
Disconnect
chute crank assembly at the discharge
chute by removing the hairpin clip and the two flat
washers. See Figure 29.
Chute
Crank
Hairpin
Figure 29
21
Hide quick links:
Advertisement
Table of Contents
