Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
Wear Protective
instruction
Gloves
manual
1. SAFETY
WARNING! ensure all Health and safety, local authority, and general workshop practice regulations are strictly adhered to when using
‰
tools.
DO NOT use tools if damaged or worn.
8
maintain the tools in good and clean condition for best and safest performance.
9
ensure all threads are clean and well lubricated.
9
ensure vehicle is adequately supported with axle stands, ramps, etc. as appropriate.
9
Wear suitable clothing to avoid snagging. do not wear jewellery. tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your sealey dealer.
9
Account for all tools and parts being used and do not leave them in or on the vehicle.
9
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or proprietary manual, to establish the correct procedure
9
and data. these instructions for use are provided as a guide only.
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
‰
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2.
INTRODUcTION
i
suitable for the installation and removal of front hub bearings without the need to dismantle the steering knuckle and strut assembly. fast and
simple to use. suitable for most front wheel drive cars. Heavy-duty steel drifts with black phosphate finish for corrosion resistance. may be used with
impact wrench.
3.
SPEcIFIcATION
i
model number ........................................................... Vs7021
drift dia. ...... 55.5, 59, 62, 65, 66, 71.5, 73, 78, 84, 86, 91mm
external sleeve diameter ............................................. 76mm
Hub screw size ....................................m12 x 1.5, m14 x 1.5
4.
OPERATION
i
fig.1
fig.3
© Jack sealey limited
instructions for
UNIVERSAL FRONT HUB & BEARING
INSTALLER
model no:
Wear eye
Protection
Original Language Version
VS7021.V4
fig.2
1.
ADJUSTING NUT
2.
WASHER
3.
DRIFT cAP
4.
BEARING
5.
HUB
6.
SLEEVE
7.
SLEEVE cAP
8.
ScREW
Vs7021.V4 issue 1 15/12/17
Advertisement
Related Manuals for Sealey VS7021.V4
Summary of Contents for Sealey VS7021.V4
- Page 1 VS7021.V4 model no: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 Important: no liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...