Preparation Of Top Cabinet; Assemble And Install Adapter; Mount The Oven - GE JVM1665 Installation Instructions Manual
Cooktop oven
Hide thumbs
Also See for JVM1665:
- Owner's manual (72 pages) ,
- Installation instructions manual (48 pages) ,
- User manual (34 pages)
Advertisement
Available languages
Available languages
A2.
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adapter.
•
Read the instructions on the top cabinet template.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions
on the top cabinet template.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
ASSEMBLE AND INSTALL
A3.
ADAPTER
NOTE: On some models, the exhaust adapter and damper
assembly may already be assembled to the oven.
Place the oven in its upright position, with the top
1
of the unit facing up.
NOTE: Make sure the blower fan blades are visible
and are pointing up.
Insert the tabs on each side of the damper
2
into the holes at the inside rear of the adapter.
Attach the exhaust adapter to the blower plate
3
with the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the oven is installed.
All manuals and user guides at all-guides.com
Installation Instructions
Damper
Exhaust
Adapter
Blower Plate
Back of
Oven
13
A4.
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over
tightening screws.
NOTE: When mounting
the oven, thread power cord
through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3.
Do not pinch cord or lift
oven by pulling cord.
2 Rotate front of oven
up against cabinet
bottom.
1
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting
plate.
Advertisement
Chapters
