Table of Contents
Advertisement
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See "Locating parts on the system board" on page 71.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
Figure 29. Connecting a SATA hard disk drive
8. To complete the installation or replacement, go to "Completing the parts replacement" on page 95.
Replacing the front audio and USB assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the User Guide. To obtain a copy of the User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 74.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 75.
4. Locate the front audio and USB assembly.
5. Disconnect the front audio and USB assembly cables from the system board. See "Locating parts on
the system board" on page 71.
Note: Make sure you note the locations of the cables when you disconnect the cables from the system
board.
94
Lenovo Hardware Maintenance Manual
Advertisement
Table of Contents
Troubleshooting
