hit counter script

Basic Sequence Of Operations - Canon LBP-1260 Service Manual

Table of Contents

Advertisement

E. Basic Sequence of Operations
Two
consecutive prints on A4 paper (Cassette
WAIT
From power-ON until the fixing
roller temperature reaches 175°C
period)
See page l-3 for warm-up time.
STBY
From the end of the WAIT period
the video controller. or from the
end of the LSTR period until a
video controller or the power is
switched OFF
After the /PRNT signal has been
input from the video controller
ROTATIONS
ready (about 6 seconds)
From the end of the INTR period
until the primary voltage (DC)
switches OFF
After the primary voltage [DC)
turns OFF until the main motor
ROTATIONS stops
period)
feed)
Figure 2-6
Table 2-l
To warm up the tilng roller to
put the printer in the standby
state and clean the transfer
charging roller.
To hold the tkdng roller at
175°C to keep the printer
ready to print.
To stabilize the sensitivity of
the drum In preparation for
transfer charging roller.
To form an image on the
to the /vDo SIgnal Input from
the video controller and to
transfer the image the paper.
To deliver the flnal page of the
Job and to clean the transfer
charging roller.
Remark
printer checks the car-
there is toner In it.
If the printer stays in the
standby state for five
hours or more. It drives
the main motor for one
second to rotate the
deformed.
roller at 190°C.
If a /PRNT signal is inpu
from the video controller,
the INITIAL ROTATIONS
period begins

Advertisement

Table of Contents
loading

Table of Contents