Table of Contents
Advertisement
Help Guide
Data Projector
VPL-CWZ10/CXZ10
Setting PJ Talk
Change the PJ Talk control protocol settings from the [Advertisement / PJ Talk / PJ Link] page.
Note
The entered value will not be applied until [Apply] is clicked.
Click the [Advertisement / PJ Talk / PJ Link] tab and display the [Advertisement / PJ Talk / PJ Link] page.
1
Configure each item under [PJ Talk] and click [Apply].
2
Settings
[Start PJ Talk Service]
Turn the PJ Talk setting on or off. The settings related to PJ Talk are applied only if it is on. The default factory setting
function is off.
[Community]: Enter the community names for Advertisement and PJ Talk. If changed, the Advertisement community
name changes as well. Only entries consisting of four alphanumeric characters are allowed. The community name in
the default factory setting is "SONY." To avoid unauthorized access to the projector from another computer, we
recommend changing the community name from the one used in the factory setting.
[Port No.]: Enter the PJ Talk server port. The default factory setting PJ Talk server port is "53484."
[Timeout]: Enter the time (in seconds) until the connection is cut when PJ Talk communication is interrupted. The time
in the default factory setting is "30."
[Host Address]: Enter the IP address allowed to be received by the PJ Talk server. If nothing is entered, commands
can be received from any IP address. Once an IP address has been entered, access will only be allowed from the
entered IP address. For security purposes, we recommend entering an IP address and restricting access.
5-014-280-13(1) Copyright 2020 Sony Corporation
102
Advertisement
Table of Contents
