Related Manuals for xanigo XD103
Summary of Contents for xanigo XD103
- Page 1 Electric Atomizer for Disinfecting INSTRUCTIONS FOR HVLP ELECTRIC ATOMIZER (XD103) Before using the atomizer, read this manual thoroughly. Any improper use can cause damage or serious injury including death.
- Page 2 Defender XD103- User Manual Disinfecting Log Sheet Area Disinfected Chemical Used Date Time...
-
Page 3: Important Safety Instructions
Be familiar with the controls and the proper usage of the equipment. WARNING: FIRE OR EXPLOSION HAZARD. Only use Xanigo approved chemicals. Other chemicals may have solvents which can generate spray material fumes that can explode or ignite. Severe injury or property damage can occur. Only clean up with water or soap &... -
Page 4: General Safety Warnings
Defender XD103- User Manual WARNING: HAZARDOUS VAPORS. Spray materials, solvents, and other materials can be harmful if inhaled or come in contact with the body. Vapors can cause severe nausea, fainting, or poisoning. To avoid these risks, take the following preventions: •... - Page 5 Defender XD103- User Manual WARNING: GENERAL. To reduce the risk of severe injury or property damage, take the following actions: • Always wear appropriate gloves, eye protection, and a respirator or mask when disinfecting. • Do not aim the atomizer at, or spray any person, including self, or animal.
- Page 6 Defender XD103- User Manual...
- Page 7 Defender XD103- User Manual I Exploded view: ST2.9*10 SCREW Needle insert Left side cover Rear cover Needle seat O-ring Cotton filter Bowl seals Atomization circle Right cover O-ring Vent spring ST3.5*10 Screw Needle spring Lock catch Switch plunger spring Needle set...
- Page 8 Defender XD103- User Manual IV Operating Instructions 1. Ensure disinfectant is prepared as per manufacturer’s instructions and atomizer is unplugged from power source. 2. Unscrew disinfectant container from atomizer. 3. Adjust suction tube orientation to match atomizer angle in use.
- Page 9 Defender XD103- User Manual 5. Remove motor/blower assembly from the atomizer. a. Hold the atomizer in your left hand and press the latch in the direction of the arrow. b. At the same time hold the motor/blower handle assembly with your right hand and rotate it counterclockwise 90 degrees.
- Page 10 Defender XD103- User Manual 8. Adjust the needle adjusting screw to meet your desired level of disinfectant coverage a. Adjust the screw to the left to decrease coverage b. Adjust the screw to the right to increase coverage Adjusting Screw 9.
- Page 11 Defender XD103- User Manual 10. Adjusting spray pattern orientation a. The fan pattern can be adjusted from horizontal to vertical by adjusting the air cap. b. Slightly loosen the air cap retaining nut and rotate air cap to desired position.
-
Page 12: Troubleshooting
Defender XD103- User Manual VI Troubleshooting Problem Cause Solution A. little or no material flow 1. nozzle clogged 1. clean 2. suction tube clogged 2. clean 3. material volume setting turned too far to the right 3. turn to the left 4.