Table of Contents
Advertisement
ATM Universal Service Module (AUSM)
•
port number
vpi
•
vci
•
•
Conn type
Service Type
•
•
mastership
Controller_Type is the optional controller specification: 1=PAR (the default}.
•
connID
•
Note
Step 2
To configure usage parameter control (UPC) for the connection (channel), use cnfupccbr, cnfupcvbr,
cnfupcrtvbr, cnfupcabr, or cnfupcubr. Use dspcons to obtain the channel number.
cnfupccbr <port.vpi.vci> <enable/disable> <pcr[0+1]> <cdvt[0+1]> <IngPcUtil> <EgSrvRate>
<EgPcUtil>
•
port.vpi.vci
enable/disable is the UPC enable: 1=disable, 2=enable.
•
pcr[0+1]
•
cdvt[0+1]
•
•
IngPcUtil
Cisco MGX 8230 Edge Concentrator Installation and Configuration
6-18
is in the range 1–8.
has a value in the range 0–255.
can be in the range 0–65535 for a VCC or * for a VPC.
is the connection type: 0=VCC, and non-0 is the local ID of a
VPC in the range 1–1000.
is the service type: 1=CBR, 2=VBR, 3=Standard ABR, 4=UBR,
5=rt-VBR, and 6=ForeSight ABR.
is the mastership status of the endpoint: 1=master, and 2=slave.
The default is slave, so you actually do not need to type a 2.
2=SPVC (PNNI).
is entered at only the master end and consists of the node name,
slot number, port number, vci, and vpi of the slave end.
To migrate between ForeSight ABR and TM 4.0 ABR, the connections must be manually
deleted and then re-added. This migration is not possible at run-time.
identifies the connection.
is the peak cell rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
–
E1, 10–4528 cells per second
–
–
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
is the cell delay variation tolerance for cells with CLP=0 and
CLP=1. The range is 1–250000 microseconds.
is the percent utilization on the ingress. The range is 1–127. The
default is 0.
Chapter 6
Card and Service Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Advertisement
Table of Contents
