Table of Contents
Advertisement
Removing/attaching the projection lens (optional)
Removing/attaching the projection lens (optional)
Move the lens to the home position before replacing or removing the projection lens. (
How to install the projection
lens
1 ) Align the mark (orange) on the
projection lens with the mark on
the projector (
LOCK), then insert the lens and turn it
clockwise until there is a click.
Ensure that the mark on the projection lens is
z
aligned with the tip of the mark (arrow) on the
projector.
2 ) Fix the projection lens with the
attached "Lens fixing screw".
Tighten the screw into the first screw hole
z
on the right side of the mark (orange) of the
projection lens with a Phillips-head screwdriver.
(There is not the projection lens fixing tap hole
on all the lenses.)
Û Some types of the lens do not have the projection lens fixing screw hole.
:
Attention
z Do not touch the lens signal receiver. Dust or dirt may cause defective contact.
z Do not touch the surface of the projection lens with your bare hands.
z Store the replaced lens where it will be free from vibration and impact.
z Turn the projection lens counter clockwise to confirm that it does not come out.
38
- ENGLISH
on the left side of
Û
How to remove the projection
lens
1 ) Remove the "Lens fixing screw".
Remove the first screw on the right side of the
z
mark (orange) of the projection lens with a
Phillips-head screwdriver.
2 ) While holding down the "LOCK
button", turn the projection lens
counterclockwise, and then pull it off.
Turn the projection lens counterclockwise until
z
its mark (orange) is aligned with the mark on
the projector (
on the left side of LOCK).
LOCK button
Æ
page 44)
Û
Advertisement
Chapters
Table of Contents
